Bedienungsanleitung WOLF-Garten Picco 32 ER (Seite 10 von 27) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Schwedisch, Norwegisch)

638492

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

Attaching of grassbox (fig. B1)

Lift deflector lid, locate grassbox hook into opening of chassis (see arrow) and replace lid.

Adjust the cutting height of wheels (fig. B2)

Only when mower is stationary and rotating blade has come to complete standstill.

1. Raise both tie rods up to stop.

2. Withdraw the axle firmly the axle guide.

3. Press the axle firmly into the desired elevation guide (the wheels must have the same elevation at each side).

4. Press in bars.

Adjust the cutting height of the roller (fig. B3)

1. Unscrew both hand wheels.

2. Lay the mower on its side.

3. Position the bolt holes at the correct cutting height and tighten using the hand wheels (adjust right and left to the same elevation).

Selection of Cutting height

If possible, mow when grass is dry in order to protect turf. Do not se cutting position too low when mowing very hight or wet grass. We recommend

an average cutting height of 3,4 cm.

Connecting to the mains (230 Volts, A.C., 50 Hz)

The mower operates from any normal household mains supply, provided with a 10 Amps. fuse.

Note: Use a residual current device (RCD) rated for a residual current not greater than 30 mA.

Insert connection cable in the strain relief (fig. M5)

Insert coupling of connection cable in the socket of the switch. Then guide the cable from outside in a slight loop over the peg of the strain

relief assembly.

Starting (fig. B4)

Switch on motor with mowerplaced on level and firm ground, not in high grass - alternatively tilt slightly.

Switch-on motor (fig. B5)

1. Depress button and hold (1).

2. Lift up bar and release button (2).

Switch-off motor (fig. B5)

Release bar (2).

Mowing

Always let cable trail on the cut side of the lawn. Cable guidance: Place the cable firmly off the lawn or on the already cur side of the

lawn when starting to mow.

Emptying of Grassbox

The grassbox is full and should be emptied as soon as grass clippings remain uncollected on the ground behind your mower.

Note: Disconnect electricity by unplugging cable at the socket-before proceeding.

Operation

Cleaning

Note: Disconnect electricity by unplugging cable at the socket before proceeding. Attention: Keep hands clear of moving blade.

Clean mower thoroughly after each mowing with cloth or brush. Do not spray with water. Keep mower in a dry room.

Change of cutter blade (fig. W1)

Note: always disconnect mains supply and wear protective gloves before undertaking any workat the cutter blades, cutter bar and

blade coupling. Change cutter blade using 10 mm spanner as illustraded. Torque wrench setting for screws 8-10 Nm. Take care to carry out

this work thoroughly. Use original spare parts only. Note: Sharpining of blades should be done by an approved service centre as the

correct balance of the blade after sharpening is very important and ought to be checked by an expert.

Winter Storage:

Clean mower thoroughly before storing away. Never spray mower with water and do not store it in a wet or humid place. Have

yourmower thoroughly checked once a yearby an approved Service Centre.

Maintenance

Faults and how to remedy

Remedy (X) by:

Problem Possible cause

WOLF service

workshop

Yourself

Uneven running, heavy vibrations

in the mower

• Blades damaged

• Blades loose in the fastening parts

---

Motor will not run

• Fuse blown

• Cable damaged

Important! If you inadvertently cut through the cable, the fuse (10

Amp.) will not always blow. In the interest of safety, never touch

damaged or servered cables before disconnecting the mains

plug. Repairing the cable with insulating tape is prohibited.

---

Poor mowing • Blunt blades X ---

Poor catching

• Blunt blades

• Catcher bag blocked

---

When in doubt, always consult a WOLF service workshop.

Important: switch off the mower and disconnect the mains plug before inspecting, cleaning or working on the blades.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten Picco 32 ER Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info