Bedienungsanleitung WOLF-Garten Premio 40 EKF (Seite 11 von 30) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

638165

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

Anti-kink protection(fig. M4)

IMPORTANT! The cable must always lie in the anti-kink protector.

Assembly of the strain relief assembly with earth rod (Fig. M5/M6/B6)

To connect the cable of the machine to the power outlet, first activate the transport safety mechanism*: Position „STOP“ M6 (1).

Then pull the required length of cable from the cable drum. Insert the cable in the strain relief assembly M5. Guide the earth rod

through the strain relief assembly and then push it into the ground. Use a hammer if necessary.

Make sure that the cable distance between the power outlet and the earth rod B6 is as short as possible. Excess unrolled cable

must be rolled up again. To do this, rotate the lower drum half clockwise M6 (3).

*Prevents the cable from accidental unrolling from the cable drum.

Important

Never switch on the machine when loose cable in loops or rings is lying on the lawn. Excess unrolled cable must be rolled up again

before switching on the machine. To do this, rotate the lower drum half clockwise M6 (3).

Connecting to the mains (230 Volts, A.C., 50 Hz)

The mower operates from any normal household mains supply, provided with a 13 Amps. fuse. Note: Use a residual current

device (RCD) rated for a residual current not greater than 30 mA.

Attaching of grassbox (fig. B1)

Lift deflector lid, locate grassbox hook into opening of chassis (see arrow) and replace lid.

Use of heigth adjustment (fig. B2)

Only when mower is stationary and rotating blade has come to complete standstill.

Place hand into handle bar and depress button. Lift or lower chassis until it engages into required position (see indicator).

Selection of cutting height

If possible, mow when grass is dry in order to protect turf. Do not se cutting position too low when mowing very hight or wet grass.

We recommend an average cutting height of 4,5 cm.

Switch-on motor - Premio 40 EKF (fig. B3/B4/M6)

Deactivate transport safety mechanism M6 (2). Switch on motor with mower placed on level and firm ground, not in high

grass - alternatively tilt slightly B3.

Depress button and hold B4 (1). Lift up bar B4 (2) and release button B4 (1). Switch-off motor: Release bar B4 (2).

Switch-on motor - Premio 40 EAKF (fig. B3/B5/M6)

Deactivate transport safety mechanism M6 (2). Switch on mower on a level surface. Not in high grass - tilt if necessary B3.

Press button and hold B5 (1). Pull left handle B5 (2) and release button B5 (1). At full motor speed by pulling the right handle Drive

on B5 (3). Setting the speed: 1st gear B5 (4) = slow (2 km/h). 2nd gear B5 (5) = fast (4 km/h). Drive off: Release drive handle

B5 (3). Motor off: Release safety handle B5 (2).

Mowing (fig. B6)

Due to the automatic cable roll-up system, you can mow in all directions. Whether you mow towards the earth rod or away from

it, the cable automatically adjusts to the necessary length..

Important

When turning, the cable bracket arm must always point in the direction of the earth rod. The cable must not be behind

the mower. The cable should only be reeled out to the yellow marking!

Emptying of grassbox (fig. B7)

Only when mower is stionary and rotating blade has come to complete standstill. Box filling indicator: The flap drops down when

grassbox is full. To ensure properfunctioning of the indicator it is important that the grilles below are kept clean using a hand brush.

After mowing (fig. B8/M5)

Unplug power cord. Remove earth rod from the ground and release cable from the strain relief assembly M5. Roll up unrolled

cable: To do this, rotate the lower cable drum half clockwise B8 (3) . Insert power plug into the storage area B8 (4) and activate the

transport safety mechanism B8 (1).

Operation

Assembly

Assembly Premio 40 EAKF

Mount the included cable clamp element (1) in such a way that the two Bowden

cables do not come into contact with the cable reel (2).

Premio 40 EAKF

Maintenance

Cleaning

Note: Disconnect electricity by unplugging cable at the socket before proceeding. Attention: Keep hands clear of moving blade.

Clean mower thoroughly after each mowing with cloth or brush (W1).

Do not spray with water. Keep mower in a dry room.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten Premio 40 EKF Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info