Bedienungsanleitung WOLF-Garten Premio 40 HA (Seite 13 von 34) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

638144

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

Please carefully retain the guarantee card completed by the seller,

or the proof of purchase.

The company WOLF-Garten provides a guarantee for 24 months from the

date of purchase. This guarantee is in accordance with the relevant state of

technology and the utilisation purpose / area of application. The consumer‘s

statutory rights are not affected by the following guarantee guidelines.

Pre-conditions for the 24-month guarantee entitlement:

- Deployment of the device solely for private use.

The guarantee is reduced to 12 months in the commercial sector

or leasing business.

- Proper handling and observance of all information given in the

operating manual, which forms part of our guarantee terms.

- Observance of the prescribed maintenance intervals.

Guarantee terms

- No unauthorised alteration of the design.

- Installation of original WOLF replacement parts / accessories.

Presentation of the completed guarantee card and/or proof of purchase.

This guarantee does not extend to normal wear-and-tear on blades,

blade mounting components or friction disks, V-belts/toothed

belts, running wheels/tyres, air filters, spark plugs and spark plug

connectors. Any guarantee claim shall be immediately void in the

event of unauthorised repairs. Faults and defects which can be traced

to material or manufacturing faults will be rectified exclusively by our

contracted workshops (the seller has the right to remedy a defect) in

your vicinity, or by the manufacturer if the latter is closer. Any claims

going beyond the provision of a guarantee are ruled out. There is

no entitlement to a replacement. Any transport damage should be

reported not to us but to the shipper in question since, otherwise, any

compensation claims vis-à-vis the shipper would be voided.

Maintenance

Sharpening and changing blade (fig. W3)

Gloves should be worn at all times when working on the

blade. Remove ignition key and spark plug lead when

working on the blade.

• Change of blades only be carried out by an approved service

station.

• Damaged blades should always be replaced in pairs to

ensure even balance.

nformation for Service Centre, blade retaining screw to be

tightened to: A/F 17 mm = 38-42 Nm / A/F 13 mm = 16-20 Nm

Adjusting the Bowden cable coupling (g. W4/B6)

1. Raise the drive bracket B6 (5) app. 2 cm and hold.

2. Loosen the locking nut W4 (1).

3. Turn the setscrew W4 (2) left until the drive wheels are

blocked when you pull the mower backwards.

4. Tighten locking nut W4 (1).

Change oil only

While engine is warm and fuel tank empty.

Change oil after the first 5 working hours. Thereafter change

engine oil every 25 working hours and at the end of the mowing

season. Change engine oil more frequently if working under

extreme and dusty conditions. To drain the engine oil, remove

oil filler cap, tilt machine slowly to side and allow oil to drain

from the crankcase through the filler. Oil Fill (B1).

Cleaning of Spark Plug

Check and clean regularly, reset plug gap as required (0,70 mm).

Cleaning of air filter

Refer to the engine manufacturer‘s handbook supplied.

Winter storage

• Drain fuel tank.

• Drain carburettor

- start engine, keep it running until it stops from fuel

Starvation

• Clean the whole machine thoroughly

• Change oil, 4-stroke engine.

• Prepare engine for winter storage as follows:

- Remove spark plug

- Poor one teaspoon full of engine oil into spark plug hole

Pull starter rope slowly to distribute oil evenly inside cylinder

- Replace spark plug but do not connect spark plug lead

Pull starter rope until resistance is felt (valves are now closed)

• Store mower in a cool and dry place.

We recommend: Have your mower thoroughly checked once a

year by approved Service Agent.

Faults and how to remedy

Remedy (X) by:

Problem Possible cause

WOLF

service-workshop

Yourself

Motor does not start or has

no power:

• Insufcient fuel in the tank

• Spark plug lead not connected

• Spark plug out of order

• Air lter dirty or oily

• Throttle lever not at „Run“

• Blade fastening screw loose

---

Uneven cutting:

• Cutting height misadjusted

• Blunt blades

• Air / duct catcher bag blocked

---

Drive does not start: • Clutch Bowden cable misadjusted --- X

When in doubt, always consult a WOLF service workshop. Important: switch off the mower and disconnect the spark plug lead

before inspecting, cleaning or working on the blades.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten Premio 40 HA Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info