Bedienungsanleitung WOLF-Garten UL 33 E (Seite 8 von 22) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

638215

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

Please check noise abatement regulations prevailing in your Country.

Operating Times

Assembly

Assembling bottom handle part (fig. M1)

Insert securing screw (A) from inside through the left side element, so that both projections catch in the recesses (1). Position insulation

element (B) from outside; the two nubs must catch in the holes of the side element (2). Position handle element (M) in the insulating element

(B). Place insulating element (C) so that the large opening points to the outside. Then press washer (D) into the opening of the insulating

element (C) and tighten wing nut (G).

Assemble the right handle element in the same order.

Assembling top of handle (fig. M2)

Attach upper handle element (N) on the lower handle elements (M), making sure that the holes (1) match. Then insert the connecting screws

from outside, put on the washers (F) and tighten the wing nuts (G).

Attaching switch, strain relief and clips (fig. M3)

Fold up switch bracket (1) and position switch (H) on the upper handle element so that the two nubs catch in the holes (2). Close switch

bracket (1) and insert cable strain relief (I). Then fasten switch (H) and cable strain relief (I) with the two screws (K). Fasten switch cable (3)

with the clips (L) on the handle rod.

Attaching protective flap (fig. M4)

Place protective flap (O) on the cover (1). Then press retainer slots (2) into the fastening flaps (3) on the cover (1).

Operation

General

Before using the machine, the lawn must be mowed to a height of about 2.5-3.5 cm. Remove the cut grass from the lawn. The lawn should be

aerated several times each year. The loosened material can be removed with a rake or catch bag*. Afterwards, the lawn should be fertilized.

* Accessories at additional cost.

Insert connection cable in the strain relief (fig. B2)

Insert coupling of connection cable (3) in the socket of the switch (H). Then guide the cable (4) from outside in a slight loop over the peg (5)

of the strain relief assembly (I).

Connection to the power outlet

(230 Volt AC, 50 Hz). The machine can be connected to any power outlet that is protected by a 10 amp fuse (or line protecting switch type K

- formerly H).

Note:

Use a residual current protection device with a residual current of no more than 30 mA.

Motor on (fig. B2)

Press button (1) and hold.

Lift lever (2) and release button (1).

Motor off (fig. B2)

Release lever (2).

Attaching catch bag* (fig. B3)

Lift protective flap (O). Hang catch bag (1) with the hooks on both bolts** of the side elements.

(* TK 33, accessory at additional cost, ** bolts included with catch bag)

height

(mm)

Moss

Weeds

Grass-

remnants

-3 X ---

4 X ---

8 --- X

Recommended working depths

Setting the working depth (Fig. B1)

The working depth is adjustable to 3 heights. Pull adjustment arm (1) away from side

cover and allow to catch in desired position (2). Adjust the height alternately left and right

by only 1 position. The adjustment arms must always be in the same height position.

Lower and middle position of aerator cylinder:

Removes moss and weeds from the lawn.

Top position of aerator cylinder:

Removes grass remnants from the lawn.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten UL 33 E Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von WOLF-Garten UL 33 E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info