697462
9
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
9
Commissioning
CS200 – 6720830475 (2015/06)
5. Fill and vent the system.
6. Commissioning the CS 200 solar controller
( Chapter 5.2, page 9)
7. Commissioning the system with the solar controller
( Chapter 5.3, page 9)
8. Check and, if necessary, adjust the settings in the service
menu of the CS 200 solar controller and perform
configuration ( Chapter 5.4, page 10)
9. Remedy warning and fault displays, if necessary, and reset
fault history
10. System handover to end user ( Chapter 5.7, page 10).
5.2 General commissioning of the solar controller
Setting the language
Turn the rotary control knob to select a language and press
the rotary control knob.
Setting the date
Turn the rotary control knob to set the day, month and year.
Continue is highlighted.
If the date is set correctly, press the rotary control knob to
apply the date.
Setting the time
Turn the rotary control knob to set the hours and the
minutes.
Continue is highlighted.
If the time is set correctly, press the rotary control knob to
apply the time.
System configuration
Turn and press the rotary control knob to start (Yes) or to
skip the configuration wizard (No).
When the configuration wizard begins, the solar controller
automatically recognises which BUS nodes (e.g. modules)
are installed in the system (system analysis) and adjusts
the menu and the factory defaults to the current system.
Perform system commissioning ( Chapter 5.3).
5.3 System commissioning with the
configuration wizard
The solar controller automatically recognises which BUS nodes
(e.g. modules) are installed in the system. The configuration
wizard adjusts the menu and the factory defaults.
The system analysis may take up to one minute.
After the configuration wizard has performed the system
analysis, the Commissioning menu is opened. The settings
must be checked here and, if necessary, adjusted and finally
confirmed.
If the system analysis is skipped, the Commissioning menu is
opened. The settings listed here must be carefully adjusted
according to the installed system. Finally, the settings must be
confirmed.
For further information on the settings refer to the technical
documentation of the modules used.
5.3.1 Commissioning the solar heating system
Menu item
Start configuration wizard?
Question Answer / setting
Check before starting the configuration wizard:
Module installed and address set?
Temperature sensor installed?
System charged and vented?
Start the configuration
wizard?
Yes | No
Operating mode
Question Answer / setting
Which system is installed?
Is the coding switch
correspondingly set at the
solar module?
Solar | DHW
Extension module
Question Answer / setting
Is an extension module
installed? (only required if
the use of a MS100 is used
in addition to the required
MS 200)
No | MS 100
Change solar configuration
Question Answer / setting
Is the solar thermal system
correctly configured with all
functions and additional
functions?
Graphic configuration of the
solar system
Speed ctrl. solar pump
Question Answer / setting
Is a solar pump with speed
control installed?
No | PWM | 0-10 V
Speed ctrl solar pump2
Question Answer / setting
Is a solar pump with speed
control installed?
No | PWM | 0-10 V
Gross collector area 1
Question Answer / setting
How large is the gross
collector area?
0 to 500 m
2
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Worcester-Bosch CS 200 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Worcester-Bosch CS 200

Worcester-Bosch CS 200 Bedienungsanleitung - Englisch - 12 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info