Bedienungsanleitung Worcester-Bosch Greenstar 1000 - GR1000W (Seite 13 von 20) (Englisch)

809221

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Malfunction or failure

Greenstar 1000 – 6721835944 (2023/08)

Fig. 9 Reduced front maintenance clearances - Front view

[A] Appliance.

[1] Above appliance - Same clearance required as for standard

clearances of 60/100 flue or 80/125mm flue.

[3] Bottom of appliance to the floor - 1,000 - 1,500mm.

[4] Below appliance - 200mm

[5] One side of appliance - Minimum 300mm.

[6] One side of appliance - Minimum 5mm.

6.2 Ventilation information

The air supply must not be restricted or contaminated.

Ventilation considerations

▶ Do not place objects to hinder the air circulation required by the

appliance.

▶ The installation premises may require ventilation to be fitted

according to its features or use.

The working pressure of the appliance should be between 0.6 bar and

3 bar. To protect the heat exchanger in the range from 0.6 bar to 1.1 bar,

the temperature limitation algorithm is activated in the heating water

outlet.

Table 7

7 Malfunction or failure

If you believe there is a problem with your central heating or hot water

supply, before you contact your installer/maintenance engineer and

report the error and appliance type carry out the following checks.

Basic checks

Some items to check before placing a call are:

• Is the electrical power switched on to the appliance?

• Is the programmer/timer set to ON or in an ON period?

• Is the room thermostat set too low?

• Is the cylinder thermostat (if fitted) set too low?

• Is the cold water main turned on?

• Sealed heating system:

– Is the static system pressure (when appliance is cold) between

1 and 1.5 bar?

•Do you have gas?

– Are other gas appliances working, gas cooker/hob for example?

– Has your credit run out on your gas pre-payment meter?

Details of your installer should be available in the Commissioning

Checklist or can be recorded in the following section.

Installer/maintenance engineer

Table 8

Worcester, Bosch Group

The appliance is supported in the UK and Eire by Worcester, Bosch

Group.

Specialist service engineers are available to attend an appliance

breakdown.

Invoices for attendance and repair work carried out on this appliance by

any third party will not be accepted.

• No charge will be made for parts and/or labour providing:

– The appliance fault is found and the appliance is within the

guarantee period. Reasonable evidence of this must be supplied

on request. i.e. a completed commissioning and service record

and has been regularly serviced at least once a year.

• A call-out charge will be made where:

– The appliance is outside the guarantee period or has not been

serviced in accordance with the manufacturers instructions.

– Our Field Service Engineer finds no fault with the appliance.

– The cause of breakdown is misuse or with other parts of your

plumbing/heating system, or with equipment not supplied by

Worcester, Bosch Group.

Working pressure (bar) Heating flow temperature (c)

1.1 86

1.0 79

0.9 72

0.8 64

0.7 57

0.6 50

0010031673-001

Installer/maintenance engineer details

Engineer name:

Company

name:

Company

address:

Telephone:

Email:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worcester-Bosch Greenstar 1000 - GR1000W Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info