Bedienungsanleitung Worcester-Bosch Greenstar CDi Classic 2015-2023 (Seite 18 von 24) (Englisch)

809247

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Fault or Breakdown

GREENSTAR CDi CLASSIC ErP – 6 720 815 728 (2015/05)

VENTILATION

This is a room sealed boiler and does not require any air for

combustion from inside the property. If a compartment is built

around the boiler after installation, then this must be carried

out as described in the Installation Manual.

SEALED HEATING SYSTEMS

This boiler is fitted to a sealed heating system which is pre-

pressurised. The optimum level for system pressure on a

Greenstar CDi Classic ErP Combination boiler is 1.5 bar

indicated on the pressure gauge.

▶ Check regularly that the pressure is maintained.

▶ Contact your installer or main ten ace engineer if a

permanent significant drop is indicated on the pressure

gauge.

CENTRAL HEATING SYSTEMS

All radiators must be heated at an even rate. If the top of a

radiator is at a lower temperature than the bottom then it

should be bled by releasing air through the bleed screw at the

top of the radiator.

Ask your installer to show you how this is done.

This boiler is fitted to a sealed system. Should water leaks be

found or if excessive bleeding is required, then a service

engineer must be contacted to inspect the installation and

rectify any fault.

Only additives that are compatible with aluminium may be used

in the system. Any incompatible additive used will invalidate

the guarantee.

6 FAULT OR BREAKDOWN

This boiler is supported in the UK and Eire by Worcester, Bosch

Group.

Specialist Service Engineers are available to attend a

breakdown occurring on this boiler.

• No charge will be made for parts and/or labour providing:

– A boiler fault is found and the boiler is within the

guarantee period. Reasonable evidence of this must be

supplied on request. i.e. the Benchmark Checklist.

• A call-out charge will be made where:

– The boiler is outside the guarantee period.

– Evidence cannot be provided that the first year service

inspection has been carried out (i.e. an entry in the

Benchmark Checklist).

– Our Field Service Engineer finds no fault with the

boiler.

– The cause of breakdown is misuse or with other parts of

your plumbing/heating system, or with equipment not

supplied by Worcester, Bosch Group.

TECHNICAL SUPPORT

In the event of a boiler fault or breakdown please contact

Worcester, Bosch Group appointments team on:

0330 123 9559.

Your advisor will arrange for an engineer to call with the

minimum of delay; under normal circumstances this will be

from 1 - 3 working days (excluding weekends and bank

holidays) for priority breakdown situations (no hot water and/

or heating).

CAUTION: Risk of damage to the boiler.

▶ Do not operate the boiler if the flue

terminal is obstructed or damaged in any

way.

For information on how to “Re-pressurise the

heating system” refer to page 13.

Invoices for attendance and repair work

carried out on this boiler by any third party will

not be accepted.

No boiler fault is found on over 30% of all

service calls.

In the case of a suspected fault, refer to the

fault finding section of this guide.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worcester-Bosch Greenstar CDi Classic 2015-2023 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info