809227
10
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
10
Maintenance
Greenstar Heatslave II 2022+ – 6 721 843 979 (2022/01)
4.3 Fault finding
4.4 System gassing
Problem Cause Remedy
Boiler stops working, blue light and
warning triangle flashing and fault
code displayed
Internal error Press the Reset button and the boiler should
restart, if not call Worcester, Bosch Group,
quoting fault codes
Boiler stops with no fault codes Possible overheat Wait 30 minutes for boiler to cool
Boiler stops working, blue light and
warning triangle flashing and fault
codes 9F 855 are displayed
Burner lockout Press the Reset button to restart the burner.
If the burner fails to fire and fault 9F 855 is
displayed again, check the oil level in the tank
Fault codes 9F 856 More than 4 attempts at a reset
during Burner lockout fault 9F 855,
no more reset attempts can be made.
Call Worcester, Bosch Group, quoting fault codes
Desired room temperature is not
reached
Thermostatic radiator valve(s) set
too low
Increase thermostatic radiator valve setting(s)
Room thermostat set too low Increase room thermostat setting
Temperature control for CH flow on
boiler set too low
Increase CH flow temperature control setting
Air trapped in heating system Bleed radiators and recharge heating system
Desired room temperature exceeded
by large amount
Radiators are too hot Turn down thermostatic radiator valves/room
stat
Room temperature rises instead of
falling
Clock is incorrectly set Check setting
No display or display unit does not
respond
Momentary power failure Switch off boiler at master switch, wait 30
seconds then switch on again
Hot water temperature too low Hot water temperature set too low Check setting
Hot water not in timed period on the
programmer
Check programmer settings
System pressure low Leak within the heating system Check system for obvious leaks
WARNING:
Caution must be exercised when venting
radiators or adjusting system pressure
after commission of your boiler.
Do not repeatedly vent your radiators, if
the problem persists, contact a heating
engineer.
Do not vent air from radiators whilst the
central heating is switched on: turn your
boiler off.
Whilst venting radiators do not allow the
pressure on the boiler to drop below the
pressure at which it is normally set.
CAUTION:
If the pressure in your heating system is
repeatedly rising (this can be checked via
the boiler pressure gauge and should be
checked when the system is cold), and
especially if you need to keep venting the
radiators, urgent action is required and
you must contact a heating engineer. This
can indicate that there is corrosion
occurring within the heating system.
This must be properly addressed to
prevent serious damage to the entire
system.
Failure to properly maintain the heating
system may affect your warranty.
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Worcester-Bosch Greenstar Heatslave II Internal wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info