Bedienungsanleitung Worcester-Bosch WR325 RSF (Seite 6 von 16) (Englisch)

809299

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

SHOWERS, BIDETS, TAPS AND MIXING VALVES

Hot and cold taps and mixing valves used in the system must be suitable for operating at

mains pressure.

Thermostatically controlled shower valves will guard against the flow of water at too high

a temperature.

If using a pressure equalising valve, set the Domestic Hot Water temperature control

knob to the MAX position.

Hot and cold mains fed water can be supplied direct to an over-rim flushing bidet subject

to local Water Company requirements.

With all mains fed systems the flow of water from the individual taps will vary with the

number of outlets operated simultaneously and the cold water mains supply pressure to

the property. Flow balancing using Ball-o-Fix type valves is recommended to avoid an

excessive reduction in flow to individual outlets. For further information contact Worcester

Heat Systems Technical Helpline.

HOT AND COLD FLOW

If the flow of water demanded from both hot and cold service outlets is dependent upon

mains supply, it may not be possible in some installations to operate all outlets

simultaneously.

WATER MAINS FAILURE

It is important to note that in the event of a mains water supply failure, no tap water will be

available until the mains supply is restored.

USE IN HARD WATER AREAS

Normally there is no need for scale protection. However, in areas of exceptionally hard

water supply it is recommended that an In-Line scale inhibitor be fitted.

Installation should be strictly in accordance with the requirements of the local Water

Company. An isolating valve to facilitate servicing should be incorporated.

The water hardness may be determined using the standard test paper or by reference to

the local Water Company.

Further information may be obtained from Worcester Heat Systems Technical Helpline.

VENTILATION OF ROOM SEALED FANNED FLUE (RSF) APPLIANCES

These are room sealed appliances and do not require a supply of air for combustion from

inside the building. Ventilation openings in a wall or door must not be obstructed. Do not

allow the flue terminal fitted on the outside wall to become obstructed or damaged.

NOTE: Do not place anything on top of the appliance. If the appliance is fitted in a

compartment do not use the compartment for storage purposes unless it conforms to the

requirements of BS 6798:1987: Section 6. It is essential that the airing space is separated

from the boiler space by a perforated non-combustible partition as described in BS

6798:1987.

FROST PRECAUTIONS

If the appliance is not to be used for a long period of time and there is a likelihood of

freezing, then the appliance should be drained. The Worcester Heat Systems Technical

Helpline will advise you on suitable frost precautions.

SERVICE

Annual servicing is important in order to ensure continuing high efficiency and long life for

your appliance. In the event of any difficulty in making suitable servicing arrangements,

Worcester Heat Systems Limited or other competent persons will discuss regular servicing

arrangements and offer a comprehensive maintenance contract.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worcester-Bosch WR325 RSF Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info