Bedienungsanleitung Workzone MWW706S-35L (Seite 13 von 16) (Englisch)

724654

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

2400W Wet & Dry Vacuum

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL No.: MWW706S-35L-1200WC • 06/2018 • 61406

(toll free)

AFTER SALES SUPPORT

(toll free)

2400W Wet & Dry Vacuum

e-mail: help@powertoolsupport.com1800 909 909

MODEL No.: MWW706S-35L-1200WC • 06/2018 • 61406

22 23

Operation Maintenance

This should ensure the locking pin on the exible hose (17) aligns with the

ridge in the exible hose outlet – blowing (8). Rotate the exible hose (17)

to the left to secure the hose into position (Fig AF)

3. Select and attach additional extension tubes if required (Refer page 16).

4. Before turning ON, ensure you are rmly holding the end of the exible

hose (17), or extension tube/s (18) if added (Fig AF).

5. Press the “I” on the

ON/OFF Switch (3)

to turn ON (Fig AG).

To turn OFF, press the

“O” on the ON/OFF

switch (Fig AH).

AH.AG.

Cleaning

WARNING! You must pull out the power plug from the mains outlet

before commencing any cleaning, maintenance or inspection work

procedures on the appliance.

• Keep all safety devices, air vents and the motor housing and appliance

head (2) free of dirt and dust.

• We recommend that you clean and dry the appliance immediately after

each use.

Cleaning the Appliance Head

• Clean the appliance head (2) regularly with a damp cloth and some soap

followed by wiping down and drying before storing away.

• Do not submerse the appliance head (2) in water or allow water to enter

the appliance head (2).

• Do not use cleaning agents or solvents. These may be aggressive to the

plastic parts on the appliance.

Cleaning the Tank

• The tank (10) can be cleaned with a damp cloth and soap or rinsed under

running water depending on the amount of dirt. Wipe down and dry

before storing away.

Cleaning the HEPA Filter

• Clean the HEPA lter (16) regularly by carefully patting it and cleaning it

with a ne brush or hand brush (not supplied).

• Do not submerse the HEPA lter in water. Do not use a damp cloth to

clean.

Cleaning the Foam Filter

• Clean the foam lter (19) with a little soap under running water.

• Allow the foam lter (19) to completely air-dry before reinstalling or

storing away. Do not wring dry.

Check the Floating Safety Valve

• Check the oating safety valve (15) often to ensure it moves freely within

the lter basket (14). To do this, take the appliance head (2) by the handle

and tip it carefully so that the lter basket (14) is facing upwards. The

oating safety valve (15) should move freely up and down.

General Maintenance

• Before each use, inspect the general condition of the appliance and check

for the following:

• Loose hardware or screws.

• Misalignment or binding of moving parts.

• Damaged or electrical wiring.

• Check lters are securely tted.

• Damaged or cracked tank.

• Any other condition that may aect safe operation

If the supply cord is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualied persons in order to avoid a hazard.

Maintenance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Workzone MWW706S-35L Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info