Bedienungsanleitung Worx Landroid M - WG791 (Seite 3 von 4) (Englisch)

641666

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Function messages

Cutting grass according to the program setting.

When it senses rain, Landroid

M will return to the Charging Base and stay there for the time you have programmed it

to do so. When dry, Landroid

M will automatically begin the delay and countdown and then return to mow. If you want

Landroid

M to mow before this, simply turn it off then on again, but only when the rain sensor is dry or you can set

the delay time to 0 min.

Needs to recharge—during the journey to the base, the cutting blade is stopped in order to save energy.

Charge is in progress—charge percentage are displayed.

Stand-by, will start according to program set.

According to the setting of “Customize work area”, Landroid

M is searching a certain area to mow.

Landroid

M has completed its charging.

Error messages

1. If Landroid

M is actually outside its territory: turn power off, take the Landroid

M inside its territory. Turn power on.

2. If the Landroid

M is inside its territory, check the LED on the charging base is green. If not, check the charging base

is connected properly to the charger and the charger is connected to a suitable power supply. If so, it means that

the boundary wire ends are clamped incorrectly, and you need to reverse them.

3. If the LED light flashes green, check the boundary wire is well connected to the clamps to the charging base. If the

problem persists, check that the boundary wire hasn’t been cut.

Refer to the "Programming" section to re-set your PIN.

1. Turn power off.

2. Turn

Landroid

upside down and check if there’s anything preventing the blade disc to rotate.

3. Remove any possible obstruction.

4. Turn

Landroid

upright and take it to an area with short grass or adjust the cutting height.

5. Turn power on.

1. Turn power off: take Landroid

M in an area free from obstacles.

2. Turn power on.

3. If the error message is still displayed; turn power off; turn Landroid

M upside-down and check if there’s anything preventing

the wheels from rotating.

4. Remove any possible obstruction, turn Landroid

M upright, turn power on.

1. Turn power off.

2. Take

Landroid

to a lawn area free from obstacles.

3. Turn power on.

4. If the error message is still displayed; turn power off; turn

Landroid

upside-down and check if there’s any debris

causing a blockage in the top cover.

5. Remove any possible obstruction, turn the

Landroid

upright, turn power on.

1. Turn power off.

2. Take Landroid

M to a lawn area clear of obstacles, turn power on.

3. If the error message is still displayed: turn power off, turn Landroid

M upside-down and check there’s nothing lifted up.

4. Remove any possible object, turn Landroid

M upright, turn power on.

Turn Landroid

M upright.

If still not work,

Firstly, position the mower on a horizontal surface.

Press Key “2” to enter the diagnosis interface, and press Key “5” for a few seconds

until the three numbers 1 2 & 3 highlighted below turn back to zero. (See Fig. A)

1. The contact between the Charging and Contact Pins may be obstructed in some way.

2. Wipe off the Charging and Contact Pins, making sure there is not an object obstructing them, then place your

Landroid

M in the charging base and check that the Pins make good connection.

1. This means that there is low battery voltage.

2. In this case you must turn

Landroid

off and place it in the Charging Base, then “charging” will be shown on screen,

which means it starts charging.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worx Landroid M - WG791 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Worx Landroid M - WG791

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info