Bedienungsanleitung Worx WG368E.9 (Seite 17 von 204) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

576045

Zoom out

Zoom in

Vorherige Seite

1/204

Nächste Seite

Cordless Chain Saw EN

motor will overload and can burn out. It

will do the job better and safer at the rate

for which it was intended.

8. Remove the saw from a cut with the saw

running at full speed. Stop the saw by

releasing the On/Off Switch. Make sure the

Chain has stopped before setting the saw

down.

9. Keep practicing on scrap logs in a secure

working area until you get the hang of

it and can saw with ease, using a ﬂuid

motion and a steady cutting rate.

Kickback safety devices on this saw

This saw has a low-kickback chain and

reduced kickback Guide Bar. Both items

reduce the chance of kickback. However,

kickback can still occur with this saw.

The following steps will reduce the risk of

kickback.

• Use both hands to grip saw while saw is

running. Use ﬁrm grip. Thumbs and ﬁngers

must wrap around saw handles.

• Keep all safety items in place on saw.

Make sure they work properly.

• Do not overreach or cut above shoulder

height.

• Keep solid footing and balance at all times.

• Stand slightly to left side of saw. This keeps

your body from being in direct line with

chain.

• Do not let guide bar nose touch anything

when chain is moving.

• Never try cutting through two logs at same

time. Only cut one log at a time.

• Do not bury the Guide Bar nose or try

plunge cut (boring into wood using guide

bar nose).

• Watch for shifting of wood or other forces

that may pinch chain.

• Use extreme caution when reentering a

previous cut.

• Use only the low-kickback chain and guide

bar that were supplied with this chain saw.

• Never use a dull or loose chain. Keep chain

sharp with proper tension.

How to use saw safely

1. Use the chain saw only with secure

footing.

2. Hold the chain saw at the right-hand side

of your body (See Fig. L).

3. The Chain (8) must be running at full speed

before it makes contact with the wood.

4. Use the metal Gripping Teeth (9) to secure

the saw onto the wood before starting to cut.

5. Use the Gripping Teeth as a leverage point

(a) while cutting. (See Fig. M)

6. Do not operate the chain saw with arms

fully extended, attempt to saw areas which

are difﬁcult to reach, or stand on a ladder

while sawing (See Fig. N).

CUTTING WOOD UNDER TENSION (See

Fig. O)

WARNING: When cutting a limb

that is under tension, use extreme

caution. Be alert for wood springing

back. When wood tension is released,

limb could spring back and strike

operator causing severe injury or death.

When sawing logs supported on both ends,

start the cut from above(Y) about 1/3 of the

diameter into the log and then ﬁnish the cut

(Z) from below, in order to avoid contact of

the chain saw with the ground. When sawing

logs supported on only one end, start the cut

from below (Y) about 1/3 of the diameter into

the log and ﬁnish the cut from above (Z) in

order to avoid log splitting or jamming of the

chain saw.

FELLING TREES (See Fig. P)

Always wear hard hat to protect head

against falling branches.

The chain saw can only be used to fell

trees smaller in diameter than the length

of the guide bar.

Secure work area. Ensure no persons

or animals are in the vicinity of the

falling tree.

Never attempt to free a jammed saw

with the motor running. Use wooden

wedges to free chain and guide bar.

When cutting and felling operations are being

performed by two or more persons, at the

same time, the felling operations should be

separated from the cutting operation by a

distance of at least twice the height of the

tree being felled. Trees should not be felled in

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worx WG368E.9 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info