Bedienungsanleitung Worx WG594E.5 (Seite 12 von 116) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

576049

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

Cordless Li-Ion Blower/Sweeper EN

ASSEMBLY

ASSEMBLING THE BLOWER TUBE

(See Fig. A & Fig. B)

Before assembling the Blower Tube (4), be

sure the on/off switch (2) is in ‘’O’’ Off position.

Fit the Blower Tube to the motor housing as

shown in Fig. A. Fix the blower tube to the

blower port with the screw provided. Check

the Blower Tube is ﬁrmly secured.

WARNING! Do not attempt to

operate or disable the On/Off

Switch by any means other than the

normal assembly or removal of the tube.

NOTE: Before disassembling the Blower

Tube, be sure the on/off switch (2) is in ‘’O’’ Off

position. Loosen the screw. Press the Release

Button (3), so that you can separate the tube

(See Fig. B). Do not try to separate the tubes

by force or by using tools.

OPERATION

INTENDED USE:

The blower is intended for blow debris.

It’s not intended for use indoors and animal

grooming.

WARNING! The charger and battery

pack are specially designed to

work together so do not attempt to use

any other devices. Never insert or allow

metallic objects into your charger or

battery pack connections because of an

electrical failure and hazard will occur.

1. BEFORE USING YOUR CORDLESS

BLOWER

Your battery pack is UNCHARGED and you

must charge once before use.

The battery charger supplied is matched to the

Li-Ion battery installed in the machine. Do not

use another battery charger.

2. CHARGING YOUR BATTERY PACK

The Li-Ion battery is protected against deep

discharging. When the battery is empty,

the machine is switched off by means of a

protective circuit:

In a warm environment or after heavy use, the

battery pack may become too hot to permit

charging. Allow time for the battery to cool

down before recharging.

3. TO REMOVE OR INSTALL BATTERY

PACK (See Fig. C)

Depress the battery release button (6) to

release battery pack from your tool. After

recharging, insert the battery pack into

tool’s battery port. A simple push and slight

pressure will be sufﬁcient.

4. STARTING/STOPPING (See Fig. D)

Starting

Move the On/Off switch (2) to the “I” On

position.

Stopping

Move the On/Off switch (2) to the “O” Off

position.

WARNING! The tool runs for a few

seconds after it has been switched off.

Let the motor come to a complete standstill

before setting the tool down.

5. USING THE BLOWER (See Fig. E)

The blower is intended for residential use

only. Use the blower outdoors to move

debris from hard surfaces. This blower is not

designed to clear leaves from large grassy

areas, or move wet, heavy debris.

USER TIPS

- Hold the blow tube approx 180mm above

the ground when operating the tool.

Use a sweeping motion from side to side.

Advance slowly keeping the accumulated

debris/leaves in front of you.

- After blowing the debris/leaves into a pile,

it is easy to dispose of the pile.

CAUTION!

- Do not blow hard objects such as

nails, bolts, or rocks.

- Do not operate the blower near

bystanders or pets.

- Use extra care when cleaning debris

from stairs or other tight areas.

- Wear safety goggles or other suitable

eye protection, long pants, and shoes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worx WG594E.5 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info