Bedienungsanleitung Worx WG776E (Seite 12 von 144) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

619547

Zoom out

Zoom in

Vorherige Seite

1/144

Nächste Seite

Cordless lawn mower EN

1312

OPERATION

1. STARTING AND STOPPING

(See Fig. E1, E2)

WARNING! The blade continues

to rotate for a few seconds after the

machine is switched off. Allow the motor/

blade to stop rotating before switching “on”

again. Do not rapidly switch off and on.

STARTING

1) Insert safety key into the housing of the

switch box.

2) Slide the key to the right and hold in

position.

3) Pull the lever bar towards the handle and

the mower will start.

4) Release the safety key.

STOPPING

Release the switch lever.

2. WORK MODE DIAL (See Fig. F)

Status1: QUIET mode

Select QUIET mode when mowing in

everyday conditions, removing approximately

20mm of grass at a time.

Status2: TURBO mode

Set the dial to TURBO mode when cutting

dense or overgrown grass.

3. BATTERY STATUS LED’S (See Fig. G)

NOTE: The Status LED’s will indicate the

battery condition when the button on

the battery is pressed.

The LED’s constantly senses and displays the

battery condition as follows:

Press the button “POWERTEST”, the light

button is illuminated.

When the three green lights are illuminated,

the battery is in a highly charged condition.

When two lights ( ) are illuminated, the

battery is in a moderately charged condition.

When only one green light ( ) is illuminated,

the battery charge is depleted.

Before using your new mower for the ﬁrst

time, it is recommended that the unit be

charged overnight to ensure that the battery is

fully charged.

IMPORTANT

When only one light is illuminated,

your battery is overly discharged, even

though the mower may still be capable

of cutting grass. Continuing to operate

your lawnmower with the battery in this

discharged condition may reduce the life

and performance of your battery.

4. ADJUSTING THE CUTTING HEIGHT

(See Fig. H)

WARNING! Stop, release switch lever

and wait until the motor stops before

adjusting height. The blades continue to rotate

after the machine is switched off, a rotating

blade can cause injury.

CAUTION: Do not touch rotating

blades.

For the ﬁrst cutting of the season, a high

cutting adjustment should be selected.

The lawnmower can be set to 5 cutting

heights between 20mm and 60mm. For this

purpose, move the cutting height adjustment

lever outwards then adjust to the preferred

position.

5. GRASS BAG FILLING INDICATOR

(See Fig. I)

To remind you immediately to empty when

the grass collection bag is full, the mower

provides an indicator on the top of bag to

show the collection status. And you can

follow as below:

Empty status: ﬂap ﬂoats (a)

Fully status: ﬂap falls down (b)

6. REAR DISCHARGE (See Fig. J)

The mower provides a rear discharge

function, so that you can mower without bag

collection. The debris will be discharged from

the rear chute.

7. MOWING TIPS

NOTE: Always inspect area where

mower is to be used and remove all

stones, sticks, wire, metal and other

debris which might be thrown by the

rotating blade.

1. Mow across the face of slopes, never up-

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worx WG776E Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info