Bedienungsanleitung Worx WX166.4 (Seite 12 von 128) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

575011

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

Lithium-Ion cordless drill/driver EN

slipping off center as the hole is started. Hold

the tool ﬁrmly and place the tip of the bit at the

point to be drilled. Depress the switch trigger

to start the tool. Move the drill bit into the

workpiece, applying only enough pressure to

keep the bit cutting. Do not force or apply side

pressure to elongate a hole.

Tungsten carbide drill bits should

always be used for concrete and

masonry. When drilling in metal, only use

HSS drill bits in good condition. Always

use a magnetic bit holder (not included)

when using short screwdriver bits. When

screw-driving, apply a small quantity of

liquid soap or similar to the screw

threads to ease insertion.

10. DISPOSAL OF AN EXHAUSTED

BATTERY PACK

To preserve natural resources, please

recycle or dispose of the battery pack

properly. This battery pack contains

Lithium batteries. Consult your local waste

authority for information regarding available

recycling and/or disposal options. Discharge

your battery pack by operating your drill, then

remove the battery pack from the drill housing

and cover the battery pack connections with

heavy-duty adhesive tape to prevent short

circuit and energy discharge. Do not attempt to

open or remove any of the components.

11. OVERLOAD PROTECTION

When overloaded, the motor comes to a stop.

Relieve the load on the machine immediately

and allow cooling for approx. 30 seconds at

the highest no-load speed.

12. TEMPERATURE DEPENDENT

OVERLOAD PROTECTION

When using as intended for the power tool

cannot be subject to overload. When the

load is too high or the allowable battery

temperature of 75°C is exceeded, the

electronic control switches off the power

tool until the temperature is in the optimum

temperature range again.

13. PROTECTION AGAINST DEEP

DISCHARGING

The Li-Ion battery is protected against deep

discharging by the “Discharging Protection

System”. When the battery is empty, the

machine is switched off by means of a

protective circuit: The inserted tool no longer

rotates.

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON

WHEN YOU PRESS THE SWITCH?

The forward/reverse rotation control, which is

on top of the trigger, is positioned in the lock

function. Unlock the forward/reverse rotation

control by putting it into the required rotation

position. Push the trigger and the drill will start

to rotate.

2. THE DRILL STOPS BEFORE THE SCREW

IS COMPLETELY TIGHTENED. WHY?

Verify the torque position of the torque

adjusting ring, you can ﬁnd the torque-

adjusting ring between the chuck and the drill

body. Position 1 is the lowest torque (screw

driving force) and position 15 is the highest

torque (screw driving force). Position is for

drill operation. Regulate the torque adjusting

ring to a higher position to reach the best

result.

3. REASONS FOR DIFFERENT BATTERY

PACK WORKING TIMES

Charging time problems, as above, and having

not used a battery pack for a prolonged time

will reduce the battery pack working time.

This can be corrected after several charge and

discharge operations by charging & working

with your drill. Heavy working conditions such

as large screws into hard wood will use up the

battery pack energy faster than lighter working

conditions. Do not re-charge your battery pack

below 0°C and above 45°C as this will affect

performance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worx WX166.4 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info