Bedienungsanleitung Xerox WorkCentre 6655 (Seite 247 von 254) (Englisch)

610826

247

Zoom out

Zoom in

Vorherige Seite

1/254

Nächste Seite

Regulatory Information

Xerox

WorkCentre

6655 Color Multifunction Printer 247

User Guide

New Zealand

1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has

accepted that the item complies with minimum conditions for connection to its network. It indicates

no endorsement of the product by Telecom, it does not provide any sort of warranty, and it does not

imply that any Telepermitted product is compatible with all Telecom network services. Above all, it

provides no assurance that any item will work correctly in all respects with another item of

Telepermitted equipment of a different make or model.

The equipment may not be capable of correct operation at the higher data speeds designated.

33.6 kbps and 56 kbps connections are likely to be restricted to lower bit rates when connected to

some PSTN implementations. Telecom will accept no responsibility for difficulties that arise in such

circumstances.

2. Immediately disconnect this equipment should it become physically damaged, then arrange for its

disposal or repair.

3. This modem shall not be used in any manner which could constitute a nuisance to other Telecom

customers.

4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There is

no guarantee that Telecom lines will always continue to support pulse dialing.

5. Use of pulse dialing, when this equipment is connected to the same line as other equipment, may

give rise to 'bell tinkle' or noise and cause a false answer condition. If you encounter such problems,

do not contact the Telecom Faults Service.

6. DTMF tones dialing is the preferred method because it is faster than pulse (decadic) dialing and is

readily available on almost all New Zealand telephone exchanges.

WARNING: No '111' or other calls can be made from this device during a mains power failure.

7. This equipment may not provide for the effective hand-over of a call to another device connected

to the same line.

8. Some parameters required for compliance with Telecom Telepermit requirements are dependent on

the equipment (computer) associated with this device. The associated equipment shall be set to

operate within the following limits for compliance with Telecom Specifications:

For repeat calls to the same number:

− There shall be no more than 10 call attempts to the same number within any 30 minute period

for any single manual call initiation, and

− The equipment shall go on-hook for a period of not less than 30 seconds between the end of

one attempt and the beginning of the next attempt.

For automatic calls to different numbers:

The equipment shall be set to ensure that automatic calls to different numbers are spaced such that

there is no less than five seconds between the end of one call attempt and the beginning of

another.

9. For correct operation, total of the RNs of all devices connected to a single line at any time should

not exceed five.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Xerox WorkCentre 6655 Seite 247

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Xerox WorkCentre 6655

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info