674716
11
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
9
Installation
SBR-32MH Ni-MH Battery Pack Installation and Use
The supplied SBR-32MH Ni-MH Battery Pack provides 9.6 Volts of DC power for your FT-
818, with a maximum capacity of 1900 mAh.
Installation
1. To install the SBR-32MH Ni-MH Battery
Pack, rst remove the battery compart-
ment cover, as described previously.
2. Lift out the FBA-28 battery holder, and
disconnect the short cable connected to
the FBA-28, as shown in the illustration.
3. Connect the short cable to the mating
connector on the SBR-32MH, and install
the SBR-32MH in the battery compart-
ment.
4. Replace the battery compartment cover.
Charging
Charging of the SBR-32MH requires the use of either the supplied battery charger (PA-48B/
C/U), or an external 13.8 Volt (±15%) DC source. If the battery charger is used, the FT-818
must be turned off during charging; if an external 13.8 Volt DC source is used (connect-
ed via the supplied E-DC-6 cable), then you may operate the FT-818 while charging is in
progress.
1. Turn the FT-818 off, then connect the supplied battery charger DC connector to the IN-
PUT: 13.8V
jack on the rear panel of the FT-818.
2. Plug the battery charger into the nearest AC wall outlet.
3. Press the FT-818’s
switch for one second to turn the transceiver on.
4. Press the
key momentarily.
5. Rotate the
knob so that the function row containing “
[
CHG, VLT, DSP
]
” appears
on the display.
6. Press the
key to select the
[
CHG
]
option (the display will immediately revert to the
regular frequency display).
7. Turn the FT-818 off. The display will indicate “CHG TIME RMN”
and remaining time to indicate the time remaining before a full
charge is achieved on the SBR-32MH.
Important Note
The PA-48 are not designed to power the transceiver for operation (reception or trans-
mission).
Please be advised that the PA-48 may contribute noise to TV and radio reception in
the immediate vicinity, so we do not recommend its use adjacent to such devices.
FBA-28
SBR-32MH
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu FT-818ND wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info