674739
9
Zoom out
Zoom in
Vorherige Seite
1/62
Nächste Seite
7
Installing the Radio
FT-891 Operating Manual
r Install the antenna and co-axial cable away from the control unit and wiring harness.
Place all cables so they do not entangle and impede the driver or passengers. Never place any
equipment in a location where it may pose a danger to the passengers, where it may interfere with
driving, or obstruct the driver field of view.
r Do not install any apparatus in such a way that it may interfere with the proper operation of the air
bags.
r After installing the radio, check that the brake lamp, head lamp, turning indicator lights, wiper, etc.
are working normally with the radio power switched on.
r Keep full attention on driving, do not operate the radio controls or look at the radio display while
driving. Stop the vehicle at a safe location, before operating the radio controls or looking at the
display.
r Do not drive the car in such a way that external sounds required for safe driving cannot be heard.
Most areas and districts prohibit the use of earphones and headphones while driving.
r If operation of the radio transmitter appears to have abnormal effects on the control equipment of
the vehicle, stop the engine, turn off the transceiver power supply, and disconnect the power cord.
Resolve the problem before continuing to operate the radio equipment.
r When using the radio in an electric or hybrid car, the receiver may experience high RF interference
and noise from the inverters that are built into the electric vehicle.
Precautions during installation
Note the following when installing this radio.
r Do not install the radio in a place where there is extreme vibration, where there is a lot of dust,
excessive humidity or high temperature, or where it is exposed to direct sunlight.
r Install the radio in a well ventilated position, so heat release is not obstructed because the heat
sink gets hot when transmitting repeatedly.
Install the Antenna
r Ensure that the antenna base is securely fixed.
r Ensure that the antenna base is securely grounded to the car body.
r Avoid routing the co-axial cable enclosed with a commercial car antenna cable.
r Do not place the co-axial cable or connectors inside the car where rain water or moisture may
penetrate them.
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu FT-891 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info