674754
24
Zoom out
Zoom in
Vorherige Seite
1/156
Nächste Seite
Page 22 FT DX 9000D OPERATION MANUAL
METER Switch
This control switch determines the function of the
Main Meter during transmission.
COMP: Indicates the RF speech compressor
level (SSB modes only).
PO: Indicates the power output level.
SWR: Indicates the Standing Wave Ratio (For-
ward: Reflected).
IDD: Indicates the final amplifier drain cur-
rent.
MIC LVL: Indicates the relative microphone level.
MONI (Monitor) Switch
This button enables the transmit (RF) monitor in all
modes (except CW, in which the monitor function
is always on, to produce the sidetone). While acti-
vated, the LED in this button glows red. Adjustment
of the Monitor level is accomplished using the
MONI knob, located just to the right of the
MONI switch.
Advice
When using headphones, the Monitor is highly use-
ful for making adjustments to the Parametric Equal-
izer or other voice quality adjustments, because the
voice quality heard in the headphones is such a “natu-
ral” reproduction of the transmitted audio quality.
MONI PITCH Knobs
MONI Knob
The inner MONI knob adjusts the audio level of the
transmit RF monitor during transmission (relative to the
AF GAIN control), when activated by the MONI but-
ton (above).
PITCH Knob
The outer PITCH knob selects your preferred CW
tone pitch (from 300 ~ 1000 Hz, in 50 Hz increments).
The Tx sidetone, receiver IF passband, and display off-
set from the BFO (carrier) frequency are all affected
simultaneously. The Pitch control setting also affects
the operation of the CW Tuning Indicator, as the center
frequency of the CW Tuning Indicator will follow the
setting of this control.
AGC ATT Knobs
AGC Knobs
This switch selects the AGC characteristics for the Main
(VFO-A) band receiver.
ATT Knobs
This switch selects the degree of attenuation, if any, to
be applied to the Main (VFO-A) receiver input.
Advice
The Attenuator may be used in conjunction with the IPO
switch (# above) to provide two stages of signal re-
duction when an extremely strong signal is being re-
ceived.
FRONT PANEL CONTROLS
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu FT-DX9000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info