674768
27
Zoom out
Zoom in
Vorherige Seite
1/173
Nächste Seite
27
Preparation
Preparing the Battery Pack/External Power Supply
Connecting to an External Power Supply Using a Power Cable
(USA/EXP version only)
The optional power cable (E-DC-6) allows the transceiver to be connected to an external
power supply.
1 Turn off the transceiver.
2 Connect the optional external power supply
cable (E-DC-6) to an external power supply.
Remarks Connect the red/black wire or white/red
wire to the positive (+) terminal of the
external power supply and the black wire
to the negative (−) terminal.
Set the voltage of the external power
supply at 12 to 14 V.
3 Insert the plug of the external power supply
into the EXT DC IN jack of the transceiver.
Cautions
y When using the transceiver with the external power supply cable (E-DC-6) connected to an external
power supply, pay attention to the following:
The power supply voltage must be between 12 V and 14 V.
If the voltage exceeds 16 V, malfunctions and damage to the electric circuits of the transceiver may
result. Take extra care.
Connect the red/black wire or white/black wire of the external power supply cable (E-DC-6) to the
positive (+) terminal of the external power supply and the black wire to the negative (−) terminal.
Use an external power supply having sufficient current capacity (3 A or more).
If the transceiver is used with the supplied antenna connected, the transmit RF may interfere with
the external power supply, resulting in malfunction or failure. When using an external power supply,
remove the supplied antenna and connect an external antenna. Place the external power supply
sufficiently away from the transceiver to avoid RF interference.
y Use the transceiver at the minimum required transmission power level to prevent overheating.
y Do not continue transmitting for a prolonged period. The transceiver may overheat, resulting in
malfunction or a burn injury.
y To operate the transceiver for 7 hours or longer, it is recommended that the battery pack be replaced
with the optional battery case (FBA-39).
y Recharging the fully-charged battery pack repeatedly can shorten its service life. Be extremely careful
not to continually recharge the battery when operating the transceiver using an external power supply.
y While charging the battery pack, protect the transceiver from water.
y Charge the battery pack in a place where the ambient temperature is +5 °C to +35 °C (+41 °F to +95
°F).
y If the terminals or electrodes of the battery pack are dirty, the transceiver may malfunction due to poor
contact, resulting in overheating or rupture. If the terminals or electrodes get dirty, clean them using
a dry cloth or cotton swab.
Connect the external
antenna.
External power supply
External power supply
cable E-DC-6
(optional)
27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu FT2DR wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info