478489
20
Zoom out
Zoom in
Vorherige Seite
1/104
Nächste Seite
VX-7R OPERATING MANUAL18
TRANSMISSION
Once you have set up an appropriate frequency inside one of the three (or four) Amateur
bands on which the VX-7R can transmit (50 MHz, 144 MHz, or 430 MHz, plus 222 MHz
on the USA version), you’re ready to transmit. These are the most basic steps; more ad-
vanced aspects of transmitter operation will be discussed later.
1. To transmit, press the PTT switch, and speak into the front panel microphone (located
in the upper right-hand corner of the speaker grille) in a normal voice level. The
STROBE” will glow red during transmission.
2. To return to the receive mode, release the PTT switch.
3. During transmission, the relative power level will be indicated on the LCD. Addition-
ally, the “L1,” “L2,” or “L3” icon will appear at the bottom of the display, correspond-
ing with the “Low Power” Level setting.
If you’re just talking to friends in the immediate area, you’ll get much
longer battery life by switching to Low Power operation. To do this, press
the key, then press the key so that the “L” icon appears at the
bottom of the display. And don’t forget: always have an antenna connected when you
transmit.
Transmission is not possible on any operating bands other than the 50 MHz, 144 MHz,
222 MHz, and 430 MHz bands.
Changing the Transmitter Power Level
You can select between a total of four transmitter power levels on your VX-7R. The
exact power output will vary somewhat, depending on the voltage supplied to the trans-
ceiver. With the standard FNB-80LI
Battery Pack and external DC source,
the power output levels available are:
To change the power level:
1. The default setting for the power output is “High;” in this configuration, the LCD
shows no indication of the power output level. Pressing the key, followed by the
key, causes the power level “L1,” “L2,” or “L3” to appear.
2. Press the key, followed by the key (repeatedly, if necessary) to make the
“Low Power” icon disappear and restore High Power operation.
1
)
The VX-7R is smart! You can set up Low power on one band (like UHF),
while leaving VHF on High power, and the radio will remember the differ-
ent settings on each band. And when you store memories, you can store
High and Low power settings separately in each memory, so you don’t waste battery
power when using very close-in repeaters!
OPERATION
50/144/430 MHz
222 MHz FM
50 MHz AM
NONE
5.0 W
L3
2.5 W
L2
1.0 W
0.3 W
L1
0.05 W
0.05 W
1.0 W
(
Fixed
)
ICONS
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

yaesu-vx-7r

Suche zurücksetzen

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu VX-7R wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info