1
Set to the “
∞
” position.
2 Turn the power on.
3 Select the desired input source by pressing the
corresponding input selector button.
* The indicator above the selected button (source) will light
up.
* Note that pressing on each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
4 Select the speakers to be used.
* If you use two speaker systems, press both the A and
B switches.
5 Play the source.
6
Adjust to the desired output level.
7 If desired, adjust the BASS, TREBLE, BALANCE and
LOUDNESS controls, etc. (refer to page 10).
Notes
●
If you select AUX, PHONO, TUNER or CD, be sure that
TAPE 1 and/or TAPE 2 are not being selected.
●
If you select TAPE 1 and TAPE 2 at the same time, the
result will be the sound from the tape deck 1.
●
For TAPE 1 and TAPE 2, whenever the button is pressed,
the corresponding input source is selected or canceled
alternately.
To turn off the power
Press the POWER switch again.
8
BASIC OPERATIONS
TO PLAY A SOURCE
