Bedienungsanleitung Yamaha CLP-611 (Seite 43 von 72) (Englisch)

590832

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

AC INLET

MIDI

AUX IN

HOST SELECT TO HOST

IN OUT

L+R

THRU

PC-2 PC-1

Mac

MIDI

AUX OUT

L+R

(CLP-811)

MIDI

AUX IN

HOST SELECT TO HOST

IN OUT

L+R

THRU

PC-2 PC-1

Mac

MIDI

AUX OUT

L+R

CLP-811/611 The Clavinova’s Device Connectors

4 AUX IN jacks (R and L/L+R)

5 AUX OUT jacks (R and L/L+R)

• AUX IN R and L/L+R

These standard phone jacks accept

connection from a synthesizer, tone-

generator module (such as the

YAMAHA DOU-10 Disk Orchestra

Unit), or other such playback

device. Sound transmitted from the

external device is produced by the

Clavinova’s internal speakers. Make

the connection (using standard

audio cord) as illustrated at right.

NOTE

A line-level mono source can be connected to the L/L+R jack.

• AUX OUT R and L/L+R

You use these standard phone

jacks to feed Clavinova output

to an external stereo recorder,

amplifier, or other such device.

This makes it possible, for

example, to record the sound to

a tape recorder or cassette, or

to produce it through external

speakers. Make the connection

(using standard audio cord) as

shown above.

When connecting to a stereo unit, set the [MASTER VOLUME] slider to center position and

adjust the volume at the recording side.

NOTE

If a line is inserted into the L/L+R jack only, the Clavinova mixes left- and right-

channel signals and outputs them over this line. This ensures that you don’t lose any

of the Clavinova’s sound.

6 MIDI IN, OUT, and THRU connectors

These are used to connect to external MIDI devices. Note that you must set the HOST SELECT

switch (described below) to MIDI in order to enable use of these connectors.

For basic information about MIDI connections and operation, refer to page 48.

7 HOST SELECT switch, and 8 TO HOST connector

TO HOST connector....

Allows direct connection to a personal computer.

HOST SELECT switch...

Sets the connection type. If connecting directly to a personal computer, you use this switch to

select the computer type. If connecting via MIDI, set this switch to the MIDI position. Refer to

“Connecting to a Personal Computer” (page 40) for detail.

Never feed AUX OUT output

back into the AUX IN jacks.

When using AUX OUT to

connect to an external device, do

not connect that device back to

the AUX IN at the Clavinova side.

Since the AUX OUT signal

always includes all sound

received at the AUX IN jacks,

interconnection will create a

feedback loop that will distort the

sound and may cause damage to

your equipment.

Audio cord (and adaptors, if

required) should be non-

resistance type.

The Clavinova’s [MASTER

VOLUME] slider and REVERB

setting do not affect the sound

received at the AUX IN jacks.

AUX IN

Audio cord

OUTPUT

Clavinova

Standard

phone plugs

MIDI

AUX IN

HOST SELECT TO HOST

IN OUT

L+R

THRU

PC-2 PC-1

Mac

MIDI

AUX OUT

L+R

DOU-10 or

Synthesizer, tone-

generator

module,...

Clavinova

MIDI

AUX IN

HOST SELECT TO HOST

IN OUT

L+R

THRU

PC-2 PC-1

Mac

MIDI

AUX OUT

L+R

Standard

phone plugs

AUX OUT

Pin-phone

adaptors

Pin plugs

Audio cord

Pin plugs

Stereo

AUX IN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha CLP-611 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha CLP-611

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info