Bedienungsanleitung Yamaha CS1X (Seite 39 von 64) (Englisch)

48730

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

REV SEND (Reverb Send): Determines the send level of the

Reverb effect.

CHO SEND (Chorus Send): Determines the send level of the

Chorus effect.

VARI SEND (Variation Send): Enables or disables the output of

the Variation effect.

Settings:

REV SEND (Reverb Send): 0~127

CHO SEND (Chorus Send): 0~127

VARI SEND (Variation Send): OFF, ON (or 0~127)

The Variation send parameters are OFF or ON when the

Variation effect is used as the Insertion effect. They are 0~127 when

used as the System effect. Normally, the Variation effect works as an

Insertion Effect when not receiving parameter change messages to

switch to System Effect from an external MIDI sequencer. For more

information about Insertion and System effects, see page 47.

■ FILTER

This sets the parameters of the filter for each Part. There are two

parameters, CUTOFF and REZ (resonance).

Generally, filters change the timbre by passing signals within a

specific frequency bandwidth and cutting others. The CS1x

features an LPF (Low Pass Filter) which passes the signals below

the specified frequency point (cutoff frequency) and cuts the

signals above it.

Depending on the voice selected, changing certain

parameters may not produce a noticeable effect.

CUTOFF: Determines the cutoff frequency of the filter, or the

frequency point above which other frequencies are filtered out.

Higher settings result in brighter sounds and lower settings

result in darker sounds.

REZ (Resonance): Sets the amount of filter resonance or

emphasis around the cutoff frequency. Higher settings produce

a higher resonant peak, while lower settings produce a relatively

flat response.

Settings:

CUTOFF: -64 ~ +63

REZ (Resonance): -64 ~ +63

NOTE

DEF

ABC

Cutoff Resonance

NOTE

■ PAN

This sets the panning (the left or right position in the stereo

spectrum) for each Part. Different pannings can be set for each

Part (for stereo output).

Settings:

Random, L63 (far left in the stereo image) to L01 to C00 (center of

a stereo image) to R01 to R63 (far right in the stereo image)

When set to "Random", the panning of each Part will

alternate between left and right each time a voice is played.

Some of the voices are preset and fixed to a panning of

"left" in the lower register and "right" in the higher register. In such a

case, you cannot modify the pan setting.

■ EFFECT

This sets the effect send (output) level for each Part. There are

three parameters: REV SEND (Reverb Send), CHO SEND (Chorus

Send) and VARI SEND (Variation Send). You can change the effect

send level for each effect in realtime when you are playing back

XG song data containing effect settings using an external MIDI

device.

When you enter Multi Play mode (reset to XG ON) by

pressing the MULTI button, each effect will be reset to the default

settings: Hall 1 (Reverb), Chorus 1 (Chorus) and Delay L,C,R (Variation).

In this case, the Reverb send level is set to 64, and the Chorus and

Variation send levels are set to 0.

Depending on the XG song data being played, the effect types

and their parameters used in the song may differ.

Note that the effect types and their parameters in the

Performance Edit mode have no relation to the effect settings

here.

Reverb Send Chorus Send

Variation Send

NOTE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha CS1X Seite 39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha CS1X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info