Bedienungsanleitung Yamaha CVP-505 (Seite 122 von 138) (Englisch)

599088

122

Zoom out

Zoom in

Vorherige Seite

1/138

Nächste Seite

122 CVP-509/505/503/501 Owner’s Manual

Troubleshooting

USB Audio function (CVP-509/505/503)

The message “This drive is busy now.” appeared, and then the

recording was aborted.

Make sure to use a compatible USB storage device (page 106).

Make sure that the USB storage device has enough memory

(page 87).

If you are using a USB memory device to which data has already

been recorded, check ﬁrst that no important data remains on the

device, then format it (page 107) and try recording again.

Audio ﬁles cannot be selected. The ﬁle format may not be compatible with the instrument. The com-

patible formats are: MP3 and WAV (CVP-509/505), WAV (CVP-503).

The DRM protected ﬁles cannot be played back.

Recorded ﬁle is played back at a different volume compared to

when it was recorded.

The audio playback volume has been changed. Setting the volume

value to 100 plays back the ﬁle as the same volume when it was

recorded (page 85).

Mixing Console

The sound seems strange or different than expected when chang-

ing a rhythm Voice (drum kit, etc.) of the Style or Song from the

Mixer.

When changing the rhythm/percussion Voices (drum kits, etc.) of the

Style and Song from the VOICE parameter, the detailed settings

related to the drum voice are reset, and in some cases you may be

unable to restore the original sound. In the case of Song playback,

you can restore the original sound by returning to the beginning of the

Song and playing back from that point. In the case of Style play, you

can restore the original sound by selecting the same Style again.

Microphone/Vocal Harmony (CVP-509/505/503)

The microphone input signal cannot be recorded. The microphone input signal cannot be recorded by Song recording.

Use the USB Audio function (page 86).

Harmony can be heard in addition to the microphone sound. Vocal Harmony is set to “ON.” Turn Vocal Harmony off (page 103).

The Vocal Harmony effect sounds distorted or out-of-tune. Your vocal microphone may be picking up extraneous sounds, such

as the Style sound from the instrument. In particular, bass sounds

can cause mistracking of the Vocal Harmony. To remedy this:

• Sing as closely to the microphone as possible.

• Use a unidirectional microphone.

•Turn down the Master volume, Style volume, or Song volume control

(pages 15, 58).

Pedal/AUX Pedal

The damper, sostenuto and soft functions do not work for the rele-

vant pedals.

The pedal cord plug is not connected. Securely insert the pedal cord

plug into the proper jack (page 113, 115, 117).

Make sure that each pedal is properly assigned to SUSTAIN, SOSTE-

NUTO, and SOFT (page 32).

The on/off setting of the footswitch connected to the AUX PEDAL

jack is reversed.

Turn the instrument’s power off, then turn on again without pressing

the footswitch.

AUX IN jacks

Sound input to the AUX IN jacks is interrupted. The output volume of the external device connected to this instrument

is too low. Increase the output volume of the external device. The vol-

ume level reproduced via this instrument's speakers can be adjusted

by using the [MASTER VOLUME] control.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha CVP-505 Seite 122

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha CVP-505

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info