Bedienungsanleitung Yamaha DSP-AZ1 (Seite 12 von 110) (Englisch)

464179

Zoom out

Zoom in

Vorherige Seite

1/110

Nächste Seite

E-10

CONTROLS AND FUNCTIONS

■ Installing batteries in the remote control

Open the battery compartment cover.

Insert three supplied batteries (LR6) in the correct

direction by aligning the + and – marks on the

batteries with the polarity markings (+ and –) on the

inside of the battery compartment.

Replace the cover as pressing until it snaps into

place.

Cautions

• Insert the batteries in the correct direction by aligning the + and –

marks on the batteries with the polarity illustrations (+ and –)

inside the battery compartment.

• Change the batteries periodically.

• Do not use old batteries together with new ones.

• Do not use different types of batteries (such as alkaline and

manganese batteries) together. Read the packaging carefully as

these different types of batteries may have the same shape and

color.

RESET

■ About changing batteries

As the batteries wear out, the operating range of the remote control

decreases and the TRANSMIT indicator does not flash or its light

becomes dim. When you notice any of these conditions, change all

of the batteries. After you insert new batteries, be sure to push

RESET in the battery compartment using a ball point pen or similar

object before using the remote control. (This does not clear the

contents of the memory.)

Caution

• If the remote control is without batteries for more than 3 minutes,

or if exhausted batteries remain in the remote control, the contents

of the memory may be cleared. When the memory is cleared,

insert new batteries, set up the manufacturer code and program

any acquired functions that may have been cleared.

■ Using the remote control

The remote control transmits a directional infrared beam. Be sure to

aim the remote control directly at the remote control sensor on the

main unit during operation.

Cautions

• When the sensor is covered or there is a large object between the

remote control and the main unit, the sensor cannot receive

signals.

• The sensor may not be able to receive signals properly when it is

exposed to direct sunlight or a strong artificial light (such as a

fluorescent or strobe light). In this case, change the direction of

the light or reposition the main unit to avoid direct lighting.

• Handle the remote control with care.

• Do not spill water or other liquids on the remote control.

• Do not drop the remote control.

• Do not leave or store the remote control in the following types of

conditions:

1 high humidity or temperature such as near a heater, stove or

bath

2 dusty places

3 in places subject to extremely low temperatures

STANDBY

/ON

INPUT MODE

INPUT SELECTOR

VOLUME

NATURAL SOUND AV AMPLIFIER DSP–AZ1

30° 30°

Approximately 6 m (20 feet)

Remote control

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha DSP-AZ1 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha DSP-AZ1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info