Bedienungsanleitung Yamaha dvd s2300 (Seite 36 von 37) (Englisch)

136634

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

TROUBLESHOOTING

■

SACD mode

■

Remote control

No picture

(U.S.A. model)

If you play a PAL system DVD-Audio, the mes-

sage “This disc is PAL system. The output is sound

only” may appear on the monitor. No picture is

available because the disc uses an incompatible

type of video signal.

—

Video cannot be recorded.

Most DVD-Audio/Video discs are copy-protected

and cannot be recorded.

—

Picture appears incorrectly.

Incorrect “TV aspect” setting on the Video menu

(in Setup).

Select the correct setting. Note that

it may be difﬁcult to adjust the

widescreen format of many DVD-

Videos to ﬁt perfectly on a 4:3

video monitor.

(U.S.A. model)

If you play PAL system DVD-Audio, the message

“This disc is PAL system. The output is sound

only.” may appear on the monitor. No picture is

available because the disc uses an incompatible

video signal system (only audio can be played).

—

(U.S.A. model)

Due to the editing method or material used on a DVD,

ghosting may occur with progressive output.

Turn off the PROGRESSIVE out-

put.

(U.S.A. model) Part of the

picture doubles during pro-

gressive output.

The video is in poor material condition or was

edited or processed inappropriately. (Video will be

played correctly via interlace output.)

Turn off the PROGRESSIVE output

to output interlaced video signals to

a video monitor.

No on-screen display

In the Setup menu, under Display,

set On-Screen Messages to On.

On-screen menu icons not

displayed or only partially

displayed on the television

Press the cursor buttons [

]

while the right-most icon is high-

lighted to change the menu bar

position.

Excessive ghosting

Use the on-screen menu icons to

adjust the picture quality.

Problem Cause Remedy Refer to page

The Setup menu settings are

not effective.

Setup menu settings are not effective in SACD

mode.

Set the parameters for SACD mode,

instead of using the Setup menu.

Some parameters may not be avail-

able.

31, 32

No digital signal is output

from the digital output jack.

Digital signals cannot be output from a Super

Audio CD.

—

Problem Cause Remedy Refer to page

The remote control does not

function properly.

The remote control was operated at an angle or dis-

tance in excess of its operating range.

The remote control will function

within a maximum range of 6 m (20

feet) and no more than 30 degrees off-

axis from the front panel.

Direct sunlight or lighting (from an inverter type of

ﬂuorescent lamp, etc.) is striking the remote control

sensor of the unit.

Reposition the unit. —

The batteries are weak. Replace all batteries with new ones. 3

DVD-S2300_G.book Page 34 Friday, October 18, 2002 2:42 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha dvd s2300 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha dvd s2300

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info