E-18
Tape A or tape B playback
1 Press the TAPE input selector button.
2 Open the DECK A or DECK B cassette compartment by
pressing the EJECT button.
3 Load the tape into the DECK A or DECK B cassette
compartment, and close the lid panel completely by
pressing the panel until it clicks.
4 Press the DOLBY B NR button so that the indicator over
the button lights up, if the tape has been recorded with
Dolby noise reduction.
* To cancel using the Dolby noise reduction, press the
DOLBY B NR button again so that the indicator over
the button goes out.
* For details on the Dolby noise reduction, refer to the
“Dolby NR (Noise Reduction) system” on page 20.
5 If necessary, switch the reverse mode to the desired one
by pressing the reverse MODE selector button so that the
corresponding indicator lights up.
The reverse MODE selector button can be operated before
or during playback, and changes tape playback as follows:
6 Select the DECK A or B in which the tape you want to play
back is loaded by pressing the DECK A/B button so that
the corresponding indicator lights up.
7 Press the play button to listen to side A, or the
play button for side B.
To stop playback
Press the stop button.
Notes
•
Switching the tape by pressing the DECK A/B button will
not stop the running (or fast running) of the tape to which
the selection has been canceled.
Before switching the tape, be sure to stop the running of
the currently selected tape.
•
When removing the tape, stop the tape if it is running, and
then open the cassette compartment.
Direct operation
Even if an input source other than tape deck is selected,
pressing the play button (or the fast wind button) will start
playback (or fast winding) directly.
TAPE DECK OPERATION
1
4
7
6
1
5
