Bedienungsanleitung Yamaha GX-707RDS (Seite 51 von 53) (Englisch)

554952

Zoom out

Zoom in

Vorherige Seite

1/53

Nächste Seite

E-43

English

CD/Video CD player

Problem

A disc cannot be played

normally, or there is a noise

during play.

Play will not begin even if

disc is loaded.

No sound or no picture.

Sound stops suddenly

(always at the same spot).

A picture is disturbed or

unstable.

Tape will not move during

playback or recording.

Recording is not possible.

Sound is distorted or fades

out, or stereo balance is poor.

Poor sound quality.

Excessive noise.

Tape travel stops in middle of

playback or recording.

The beginning of desired

selections on tape cannot be

found.

Beginning of the track isn’t

recorded.

Remote control does not

work.

TV functions strangely when

the remote control is used.

Cause

The disc is not a standard type.

Disc is upside down.

Disc is dirty.

The input source selection is incorrect.

Disc is dirty.

Volume is set too high.

Setting of the TV MODE switch on the rear

panel is improper.

Slack tape wrapped around pinch roller.

Erasure prevention tab is broken off.

Head is dirty.

Tape is worn.

Tape encoded with Dolby NR is played back

with this system’s Dolby NR off.

Tape not encoded with Dolby NR is played

back with this system’s Dolby NR on.

Head has become magnetized.

Slack tape coming out of cassette shell.

Tape is creased or torn.

Endless tape is being used.

Silent gaps between selections are too short.

Excessively soft passages in middle of

selections.

Conversation, etc. is recorded.

There is an unrecordable part in the first few

seconds of the tape.

Batteries are dead.

Remote control is too far away or tilted too

much.

Direct sunlight or lighting (of an inverter

type fluorescent lamp, etc.) is striking the

remote control sensor of the main unit.

Remote control is being used near TV set

with a remote control sensor.

What to Do

Play another disc.

Load disc with label side facing upward.

Clean disc.

Select the CD/Video CD player by pressing INPUT

or button until “VCD/CD” lights up on the display.

Clean disc.

Lower volume.

Set the TV MODE switch to proper position.

Tighten slack with a pencil (pen) before using.

Replace tape or cover erasure prevention hole with

adhesive tape.

Clean heads.

Replace tape.

Press the DOLBY NR button to turn it on.

Press the DOLBY NR button to turn it off.

Demagnetize heads with head demagnetizer.

Tighten slack with a pencil (pen) before using.

Replace tape.

Do not use endless tapes.

The function of searching for the beginning of desired

selections will not operate unless the silent gaps

between selections are at least four seconds long.

Wind the unrecordable part of the tape and start

recording from the recordable part.

Replace batteries.

Use within 6 m and 60° radius.

Reposition the main unit.

Relocate the main unit away from the TV.

Tape deck

Appendix

Remote control

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha GX-707RDS Seite 51

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info