Bedienungsanleitung Yamaha GX900 (Seite 57 von 61) (Englisch)

29934

Zoom out

Zoom in

Vorherige Seite

1/61

Nächste Seite

English

E-49

Appendix

Problem

Tape will not move during playback or

recording.

Recording is not possible.

Sound is distorted or fades out, or stereo

balance is poor.

Poor sound quality.

Excessive noise.

Tape travel stops in middle of playback or

recording.

The beginning of desired selections on

tape cannot be found.

The MD recorder does not respond to

operations.

Play is not possible.

Recording is not possible.

The MD cannot be removed when

partially inserted.

Remote control does not work.

TV functions strangely when the remote

control is used.

What to Do

Take up slack with a pencil before using.

Replace tape or cover erasure prevention hole

with cellophane tape.

Clean heads.

Replace tape.

Press the DOLBY NR button to select the

appropriate mode.

Clean heads.

Demagnetize heads with head eraser.

Take up slack by turning reels with a pencil.

Replace with new tape.

Do not use endless tapes.

The function of searching for the beginning of

desired selections will not operate unless the

silent gaps between selections are at least four

seconds long.

Replace the current disc with a new one.

Reload the disc with the label side facing up, and

the arrow pointing toward the disc insertion slot.

Insert a recorded disc.

Slide the protection tab to the closed position.

Load a recordable disc.

Press INPUT or repeatedly to select the

correct input source.

Load a recordable disc with fewer recorded

tracks, or erase unnecessary tracks from the

current disc.

Insert the disc completely, then press to eject

it.

Replace batteries.

Use within 6 m and 60° radius.

Change position of the main unit.

Relocate the main unit away from the TV or cover

TV’s remote control sensor.

MD recorder

Tape deck

Cause

Slack tape wrapped around pinch roller.

Erasure prevention tab is broken off.

Head is dirty.

Tape is worn.

Tape encoded with Dolby NR is played

back with this system’s Dolby NR off, and

vice versa.

Head is dirty.

Head has become magnetized.

Slack tape coming out of cassette shell.

Tape is creased or torn.

Endless tape is being used.

Silent gaps between selections are too

short.

Excessively soft passages in middle of

selections.

Conversation, etc. is recorded.

Disc is dirty or damaged.

Disc is damaged (“UTOC ERR appears

on the display).

Disc has been loaded incorrectly.

An unrecorded (blank) disc was loaded

(“Blank Disc” appears on the display).

Disc is protected against recording.

(“Protected” appears on the display).

A pre-mastered MD is loaded

(“PlaybackMD” appears on the display).

The input source selection is incorrect.

There is not enough blank space left on

the disc.

The carriage lock function has worked.

Batteries are dead.

Remote control is too far away or tilted too

much.

Direct sunlight or lighting (of an inverter

type of fluorescent lamp, etc.) is striking

the remote control sensor of the main unit.

Remote control is being used near TV set

with a remote control sensor.

Remote control

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha GX900 Seite 57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info