425042
18
Zoom out
Zoom in
Vorherige Seite
1/29
Nächste Seite
Front & Rear Panels
MG206C/MG166CX/MG166C Owner’s Manual
Reference
18
C Master SEND Controls (AUX, EFFECT)
Adjusts the signal level sent to the SEND (AUX, EFFECT)
jacks.
If you are using the MG166CX, the Master SEND
control (EFFECT) does not affect the level of the sig-
nal sent from the EFFECT bus to the internal digital
effect processor.
D MONITOR/PHONES
MONITOR switches
These switches select the signal sent to the MONITOR OUT
jacks, PHONES jack and the level meter from STEREO L/R
bus, GROUP 1/2 bus or GROUP 3/4 bus.
STEREO L/R bus: STEREO ( )
GROUP 1/2 bus: GROUP ( ), 1-2 ( )
GROUP 3/4 bus: GROUP ( ), 3-4 ( )
MONITOR Control
Controls the level of the signal output to the PHONES jack
and the MONITOR OUT jacks.
E 2TR IN
2TR IN Switch
If this switch is set to TO MONITOR ( ), the signals input
via the 2TR IN jacks are sent to the MONITOR OUT jacks,
the PHONES jack, and the level meter. If it is set to TO STE-
REO ( ), the signals are sent to the STEREO L/R bus.
2TR IN Control
Adjusts the level of the signal sent from the 2TR IN jacks.
The following illustration shows how the switch settings cor-
respond to the signal selection.
*: When overdubbing, you can adjust the levels of the mon-
itor playback signal and the signal being recorded separately.
MONITOR MIX Signal Flow
If the input channel PFL switch is on ( ), then only
the PFL output from that channel is sent to the MON-
ITOR OUT jacks, PHONES jack, and level meter.
F GROUP 1-2 Fader
Adjusts the signal level sent to the GROUP OUT 1/2 jacks.
G GROUP 3-4 Fader
Adjust the signal level to the GROUP OUT 3/ 4 jacks.
H ST Switch
If this switch is on, the signals are sent to the STEREO L/R
bus via the GROUP 1-2 fader or GROUP 3-4 fader. The
GROUP 1 and 3 signals go to STEREO L and the GROUP 2
and 4 signals go to STEREO R.
I STEREO OUT Master Fader
Adjusts the signal level sent to the STEREO OUT jacks.
Switches
Signals output via the
MONITOR/PHONES
jacks
PFL
MONITOR/
PHONES
2TR IN
ON
PFL
OFF
STEREO
TO STEREO
STEREO (+ 2TR IN)
TO MONITOR
STEREO + 2TR IN
*
GROUP
1-2
TO STEREO
GROUP 1-2
TO MONITOR
GROUP 1-2 (+ 2TR IN)
3-4
TO STEREO
GROUP 3-4
TO MONITOR
GROUP 3-4 (+ 2TR IN)
NOTE
Playback
signal
Recording
signal
2TR IN
2TR IN control
STEREO OUT Master fader
MONITOR/PHONES controls
STEREO
bus
REC OUT
jacks
MONITOR
OUT/PHONES
jacks
NOTE
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yamaha mg166c 16 kanaals mengpaneel wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info