Bedienungsanleitung Yamaha MG24-14fx (Seite 3 von 28) (Englisch)

618045

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

MG32/14FX, MG24/14FX

PRECAUTIONS

PLEASE READ CAREFULLY BEFORE PROCEEDING

* Please keep this manual in a safe place for future reference.

WARNING

Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock,

short-circuiting, damages, ﬁre or other hazards. These precautions include, but are not limited to, the following:

• Only use the voltage speciﬁed as correct for the device. The

required voltage is printed on the name plate of the device.

• Use only the included power cord.

• Do not place the power cord near heat sources such as

heaters or radiators, and do not excessively bend or otherwise

damage the cord, place heavy objects on it, or place it in a

position where anyone could walk on, trip over, or roll anything

over it.

• Be sure to connect to an appropriate outlet with a protective

grounding connection. Improper grounding can result in

electrical shock.

• Do not open the device or attempt to disassemble the internal

parts or modify them in any way. The device contains no

user-serviceable parts. If it should appear to be

malfunctioning, discontinue use immediately and have it

inspected by qualiﬁed Yamaha service personnel.

• Do not expose the device to rain, use it near water or in damp

or wet conditions, or place containers on it containing liquids

which might spill into any openings.

•Never insert or remove an electric plug with wet hands.

• If the power cord or plug becomes frayed or damaged, or if

there is a sudden loss of sound during use of the device, or if

any unusual smells or smoke should appear to be caused by it,

immediately turn off the power switch, disconnect the electric

plug from the outlet, and have the idevice inspected by

qualiﬁed Yamaha service personnel.

• If this device should be dropped or damaged, immediately turn

off the power switch, disconnect the electric plug from the

outlet, and have the device inspected by qualiﬁed Yamaha

service personnel.

CAUTION

Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage to the

device or other property. These precautions include, but are not limited to, the following:

• Remove the electric plug from the outlet when the device is not

to be used for extended periods of time, or during electrical

storms.

• When removing the electric plug from the device or an outlet,

always hold the plug itself and not the cord. Pulling by the cord

can damage it.

• When transporting or moving the device, always use two or

more people.

• Before moving the device, remove all connected cables.

• When setting up the product, make sure that the AC outlet you

are using is easily accessible. If some trouble or malfunction

occurs, immediately turn off the power switch and disconnect

the plug from the outlet. Even when the power switch is turned

off, electricity is still ﬂowing to the product at the minimum

level. When you are not using the product for a long time,

make sure to unplug the power cord from the wall AC outlet.

•Avoid setting all equalizer controls and faders to their

maximum. Depending on the condition of the connected

devices, doing so may cause feedback and may damage the

speakers.

• Do not expose the device to excessive dust or vibrations, or

extreme cold or heat (such as in direct sunlight, near a heater,

or in a car during the day) to prevent the possibility of panel

disﬁguration or damage to the internal components.

• Do not place the device in an unstable position where it might

accidentally fall over.

•Never block the vent holes during use. Vent holes are located

on the top, bottom, front, rear, and sides of this machine. All

vent holes must remain unblocked to prevent overheating.

To further ensure adequate ventilation, never use this device…

- Upside down or on its side

- In a poorly ventilated location (in a closet, inside a

bookcase, etc.)

- With its rubber footpads removed

- On a thick carpet or other such surface

- While it is inside an unventilated touring case

Failure to observe the above precautions may cause the

device to overheat, resulting in equipment damage and ﬁre

hazard.

• Do not use the device in the vicinity of a TV, radio, stereo

equipment, mobile phone, or other electric devices. Otherwise,

the device, TV, or radio may generate noise.

• Before connecting the device to other devices, turn off the

power for all devices. Before turning the power on or off for all

devices, set all volume levels to minimum.

• Do not insert your ﬁnger or hand in any gaps or openings on

the device (vents, etc.).

•Avoid inserting or dropping foreign objects (paper, plastic,

metal, etc.) into any gaps or openings on the device (vents,

etc.). If this happens, turn off the power immediately and

unplug the power cord from the AC outlet. Then have the

device inspected by qualiﬁed Yamaha service personnel.

• Do not use the device or headphones for a long period of time

at a high or uncomfortable volume level, since this can cause

permanent hearing loss. If you experience any hearing loss or

ringing in the ears, consult a physician.

• Do not rest your weight on the device or place heavy objects

on it, and avoid use excessive force on the buttons, switches or

connectors.

Power supply/Power cord

Do not open

Water warning

If you notice any abnormality

Power supply/Power cord

Location

Connections

Handling caution

Yamaha MG24-14fx Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info