Bedienungsanleitung Yamaha MG32-14fx (Seite 21 von 28) (Englisch)

618044

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Front & Rear Panels

MG32/14FX, MG24/14FX

7 ST INSERT I/O (L, R) Jacks

These are balanced TRS (tip, ring, sleeve) phone-type bidirec-

tional jacks. You use these jacks, for example, to connect to an

external effector, submixer, or other such device.

Connection to an INSERT I/O jack requires a spe-

cial separately-sold insertion cable such as illus-

trated below.

8 ST SUB OUT Jacks (L and R)

These are impedance-balanced phone output jacks. These jacks

output a clone of the mixed stereo signal from the ST bus. The

level for this output is adjusted by the ST SUB OUT control in

the Master Control block (see page 13). You would typically

use these jacks to connect to an external mixer or a supplemen-

tary SR system.

The ST master fader does not operate on the sig-

nals from these jacks.

9 ST OUT Jacks (L, R)

These are balanced XLR output jacks. These jacks output the

mixed stereo signal from the mixer’s ST bus. The level for this

output is adjusted by the ST master fader in the Master Control

block (see page 13). You typically use the jacks to connect to

your main output, such as to the power ampliﬁers driving your

main speakers.

0 MONO Jack

This balanced XLR input jack outputs a monaural mix of the

stereo signal from the ST bus. The level for this output is con-

trolled by the MONO fader in the Master Control block (see

page 13). The output is a mix of the ST bus’s L and R signals.

A FOOT SWITCH TAP Jack

This phone input jack is for connection to a foot switch, for use

with the TAP DELAY feature. If you connect the (separately

sold) YAMAHA FC5 foot switch to this jack and then set inter-

nal EFFECT 2 to [16] TAP DELAY, you can use the foot

switch (as an alternative to the TAP button) to set the delay.

The mixer will automatically set the delay to the interval

between the last two taps.

B POWER Switch

Use this switch to turn the mixer’s power ON and OFF. Press

the switch in to set the power on ( ), and press again to set

the power off ( ).

C AC IN Connector

Connects to the socket end of the AC power cord included with

the mixer.

Connector Polarities

*These jacks also accept connection to monaural phone plugs. If you use monaural plugs, the connection will be unbalanced.

NOTE

To the INSERT I/O jack

To the input jack of the external processor

To the output jack of the external processor

Ring

Sleeve

Tip

Sleeve

Tip

NOTE

INPUT A, ST OUT, MONO

Pin 1: Ground

Pin 2: Hot (+)

Pin 3: Cold (–)

MIC (Talkback)

Pin 1: Ground

Pin 2: Hot (+)

Pin 3: Ground

INPUT B, GROUP OUT, AUX SEND (1 to 6),

EFFECT SEND (1, 2), ST SUB OUT*

Tip: Hot (+)

Ring: Cold (–)

Sleeve: Ground

INSERT I/O,

GROUP INS I/O, ST INSERT I/O

Tip: Output

Ring: Input

Sleeve: Ground

PHONES

Tip: L

Ring: R

Sleeve: Ground

Stereo channel input jacks,

RETURN (1, 2)

Tip: Hot

Sleeve: Ground

Stereo channel input jacks,

2TR IN,

REC OUT

INPUT OUTPUT

INPUT

Ring

Sleeve Tip

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha MG32-14fx Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info