530341
72
Zoom out
Zoom in
Vorherige Seite
1/240
Nächste Seite
Quick Guide Using the Controllers—Advanced Course
Controllers supported by the MO
72
Owner’s Manual
Changing Control Change numbers
The functions assigned to the controllers by the Controller Set and ASSIGN A/B functions are applied only to the internal
tone generator block.
For connected external MIDI instruments, use of the controllers generates MIDI Control Change messages, as assigned in
the chart below.
* The MO does not have the following MIDI controllers: Aftertouch, Ribbon Controller, Foot Controller 2 jack, or Breath Controller jack. However, keep in mind
that if the same MIDI Control Change messages as set here are received from an external device, the internal tone generator also responds to those
messages as if the unsupported/unavailable MIDI controller was used on the MO.
Conventional controllers, such as Modulation wheel, will affect connected MIDI instruments in their conventional way. For
example, when the pan function is assigned to the Modulation wheel under Controller Set, using the Modulation wheel will
apply the pan function to the internal tone generator, but will transmit the Modulation messages to an external MIDI
instrument.
Keep in mind also that if the same MIDI Control Change messages as set here are received from an external device, the
internal tone generator also responds to those messages as if the controller on the MO itself was used.
Controller Generated MIDI message Display for setting the Control Change number
Aftertouch* Channel Aftertouch (DnH)
Pitch Bend wheel Pitch Bend (EnH)
Modulation wheel Control Change (BnH, 01H)
ASSIGN A, B Control Change (BnH) [UTILITY] [F4] CTL ASN [SF2] ASSIGN
Footswitch Control Change (BnH) [UTILITY] [F4] CTL ASN [SF3] FT SW
Ribbon Controller* Control Change (BnH) [VOICE] [UTILITY] [F3] VOICE [SF4] CTL ASN
[PERFORM] Performance selection [EDIT] [COMMON] [F4] CTL ASN
[SONG]/[PATTERN] Song/Pattern selection [MIXING] [EDIT] [COMMON] [F4]
CTL ASN
ASSIGN 1, 2
Foot Controller 1, 2*
Breath Controller*
Using the Controllers for two different functions
You can also set up a controller such that it sends one kind of Control message to the internal tone generator of the MO,
yet another kind of message to the MIDI Out. For example, in a Controller Set you could assign Resonance to ASSIGN
1 (Knob 3). Then, in the Utility mode, you could assign Control Change number 1 (modulation) to the same Knob. Now,
when you move Knob 3, resonance will be applied to the sound of the internal tone generator block, while modulation
messages will be transmitted to the external MIDI instrument.
External MIDI
instrument
Controller
Tone generator
block
Transmitting the Control Change messages
Affecting the destination (Dest)
TIP
72

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

yamaha-mo8

Suche zurücksetzen

  • auf dem Display erscheint: without system?
    was mussich tun? Eingereicht am 13-1-2021 18:00

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yamaha MO8 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Yamaha MO8

Yamaha MO8 Bedienungsanleitung - Deutsch - 239 seiten

Yamaha MO8 Bedienungsanleitung - Französisch - 239 seiten

Yamaha MO8 Bedienungsanleitung - Portugiesisch - 240 seiten

Yamaha MO8 Bedienungsanleitung - Spanisch - 240 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info