Bedienungsanleitung Yamaha MOTIF ES6 (Seite 25 von 300) (Englisch)

571271

Zoom out

Zoom in

Vorherige Seite

1/300

Nächste Seite

Rear Panel

Owner’s Manual

The Controls & Connectors

#GAIN knob Page 73

For adjusting the input gain of the audio at the A/D INPUT

jacks (above). Depending on the connected device

(microphone, CD player, etc.), you may need to adjust this

for optimum level.

$CARD (Card slot) Page 27

Insert a SmartMedia (memory) card here to transfer

various data to/from this instrument. Read carefully the

precautions on using a SmartMedia (page 28) before

inserting a SmartMedia card.

%Plug-in board cover Page 283

Installing an optional Plug-in Board to this instrument lets

you greatly expand the sonic palette of the instrument. Up

to three boards can be installed to the rear panel.

■When the optional mLAN16E has been

installed:

1mLAN (IEEE1394) connector 1, 2

For connecting mLAN devices or IEEE1394-compatible

(FireWire) devices via standard IEEE1394 (6-pin) cables.

* The name “mLAN” and its logo (above) are trademarks.

nThe digital audio output via the mLAN connector is ﬁxed to a

resolution of 24 bit/44.1 kHz.

■When the optional AIEB2 has been

installed:

1OPTICAL IN, OUT connectors Pages 33, 34

Use these connectors to input or output digital signals

over optical-ﬁber cable. You can use the OPTICAL IN to

record a digital signal at frequencies of 48kHz, 44.1kHz,

or 32kHz. The OPTICAL OUT connector outputs a digital

signal of 44.1kHz.

2DIGITAL IN, OUT connectors Pages 33, 34

Use these connectors to input or output digital signals

over coaxial (RCA-pin) cable. The digital signal format is

CD/DAT (S/P DIF). You can use the DIGITAL IN connector

to record a digital signal at frequencies of 48kHz,

44.1kHz, or 32kHz. The DIGITAL OUT connector outputs a

digital signal of 44.1kHz.

3ASSIGNABLE OUT jacks (AS1 to AS6) Page 31

Line level audio signals are output from this instrument via

these phone jacks (1/4" mono phone plug).

These outputs are independent of the main output (at the

L/MONO and R jacks above), and can be freely assigned

to any of the Drum Voice key or the Parts. This lets you

route speciﬁc Voices or sounds for processing with your

favorite outboard effect unit.

The parts which can be assigned to these jacks are as

follows:

• Drum Voice key to which the drum/percussion instrument is

assigned Page 203

• Any part of a Performance* Page 218

• Any part of a Song* Page 235

• Any part of a Pattern* Page 235

* Including the Audio Input part

nDigital audio output via the OPTICAL OUT connector or DIGITAL

OUT connector can be changed between 20-bit and 24-bit

resolution in the [UTILITY] → [F2] I/O → [SF2] OUTPUT display.

The frequency, however, is ﬁxed at 44.1 kHz.

About mLAN

“mLAN” is a digital network designed for musical applications.

It uses and extends the industry standard IEEE 1394 high

performance serial bus.

For details, refer to the Guide Book of the mLAN16E.

mLAN EXPANSION BOARD mLAN16E

ACTIVE MADE IN JAPAN

IEEE1394

1 2 3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha MOTIF ES6 Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha MOTIF ES6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info