Bedienungsanleitung Yamaha MOXF (Seite 67 von 80) (Englisch)

707405

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

MOXF6/MOXF8 Owner’s Manual

Appendix

 Are the filter settings appropriate?

Excessively high filter resonance settings can cause distortion.

 Are any of the following volume parameters set so high that clipping is occurring?

Sound is cut off.

 Is the entire amount of notes played (via your keyboard playback and Song/Pattern/Arpeggio playback) exceeding the maximum

polyphony of this instrument?

Only one note sounds at a time.

 When this situation occurs, the Mono/Poly parameter in the current mode is set to “mono.” If you wish to play chords, set this parameter

to “poly.”

Pitch is wrong.

 Is the Master Tune parameter in the Utility mode set to a value other than “0”?

 Is the Note Shift parameter in the Utility mode set to a value other than “0”?

 When the Voice produces a wrong pitch, is the appropriate tuning system selected from Micro Tuning parameter in the Voice Edit

mode?

 When the Voice produces a wrong pitch, is the LFO Pitch Modulation Depth in the Voice Edit mode set too high?

 When the Voice produces a wrong pitch, is the Coarse Tune or the Fine Tune in the Voice Edit mode set properly?



When the Performance/Song/Pattern produces a wrong pitch, are the Note Shift and Detune parameters of each Part set to a value other

than “0”?



When the Song/Pattern playback produces a wrong pitch, is the Note Offset parameter in the Groove display set to a value other than “0”?

No effect is applied.

 Check the on/off status of the EFFECT [INSERTION]/[SYSTEM]/[MASTER] button.

 Is the Reverb Send or Chorus Send set to a value other than “0”?

[VOICE]  [EDIT]  Element/Key selection  [F3] FILTER

[PERFORM]  [EDIT]  Part selection  [F4] TONE  [SF1] FILTER

[SONG]/[PATTERN]  [MIXING]  [EDIT]  Part selection  [F4] TONE  [SF1] FILTER

[UTILITY]  [F1] GENERAL  [SF1] TG  “Volume”

[VOICE]  [EDIT]  [COMMON]  [F2] OUTPUT  Volume

[VOICE]  [EDIT]  Element/Key selection  [F4] AMP  [SF1] LVL/PAN  “Level”

[PERFORM]  [EDIT]  [COMMON]  [F2] OUT/MFX  [SF1] OUT  “Volume”

[PERFORM]  [EDIT]  Part selection  [F2] OUTPUT  [SF1] VOL/PAN  “Volume”

[SONG]/[PATTERN]  [MIXING]  [EDIT]  Part selection  [F2] OUTPUT  [SF1] VOL/PAN  “Volume”

[VOICE]  [F4] PORTA  “Mono/Poly”

[PERFORM]  [EDIT]  Part selection  [F1] VOICE  [SF2] MODE  “Mono/Poly”

[SONG]/[PATTERN]  [MIXING]  [EDIT]  Part selection  [F1] VOICE  [SF2] MODE  “Mono/Poly”

[UTILITY]  [F1] GENERAL  [SF1] TG  “Tune”

[UTILITY]  [F1] GENERAL  [SF1] TG  “NoteShift”

[VOICE]  [EDIT]  [COMMON]  [F1] GENERAL  [SF2] PLY MODE  “M. Tuning No.”

[VOICE]  [EDIT]  Element/Key selection  [F5] LFO  “PMod”

[VOICE]  [EDIT]  Element/Key selection  [F2] PITCH  “Coarse” / “Fine”

[PERFORM]  [EDIT]  Part selection  [F4] TONE  [SF1] TUNE

[SONG]/[PATTERN]  [MIXING]  [EDIT]  Part selection  [F4] TONE  [SF1] TUNE

[SONG]/[PATTERN]  [F2] GROOVE  “NOTE OFST”

[VOICE]  [EDIT]  [COMMON]  [F2] OUTPUT  “ChoSend” / “RevSend”

[PERFORM]  [EDIT]  [COMMON]  [F2] OUT/MFX  [SF1] OUT  “ChoSend” / “RevSend”

[SONG]/[PATTERN]  [MIXING]  [EDIT]  Part selection  [F2] OUTPUT  [SF1] VOL/PAN  “ChoSend” / “RevSend”

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha MOXF Seite 67

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha MOXF

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info