555601
5
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
5 En
English
Before making connections, make sure that the amplifier is
switched off.
When connecting the speaker cable
Do not let the bare speaker wires touch each other as this
could damage the speaker or the amplifier.
Make sure you connect the speakers with the correct
polarity—positive (+) terminals to positive (+)
terminals, and negative (–) terminals to negative (–)
terminals. If you get them crossed over, the sound will be
unnatural and lack bass.
Please refer to the owner’s manual that came with your
amplifier or receiver.
How to connect the speaker cables
1. Loosen the terminal knob.
2. Remove 10 mm (3/8") of insulation from each end of the
cables, and twist the exposed conductors together neatly
and tightly, as shown below.
3. Insert the bare wire.
4. Tighten the knob and secure the cable.
5. Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Notes
When using an amplifier with a rated output power higher
than the nominal input power of the speaker, care should be
taken never to exceed the speaker’s maximum input.
The speaker may be damaged if certain sounds are
continuously output at high volume level. For example, if sine
waves from a test disc, bass sounds from electronic
instruments, etc., are continuously output, or when the stylus
of a turntable touches the surface of a disc, reduce the volume
level to prevent the speaker from being damaged.
When using a banana plug
1. Tighten the terminal knob.
2. Simply insert the banana plug into the terminal.
The speaker and the grille are packed separately. To attach the
grille, line up the projections (magnets) on the reverse side of
the grille with their corresponding screw heads on the speaker.
Notes
When removing the grille, be careful not to touch the drive
units, and not to exert excessive force with any tools.
Do not touch or apply impact to the speaker's diaphragm.
Otherwise, the speaker may malfunction.
There are magnets on the reverse side of the grille. Do not
place the grille close to objects that might be affected by
magnets, such as CRT TV, clock, magnetic card, diskette,
etc., after removing it.
CONNECTING TO YOUR
AMPLIFIER
Standard connections
Loosen
Tighten
Black (–)
Insulation coating
Red (+)
Bare wire
NS-B500
(Right) (Left)
Amplifier or
Receiver
Speakers
output
terminals
Note
Do not insert the insulation into the hole.
If the connections are faulty, you will hear no sound
from the speaker.
NS-B500
10 mm
(3/8")
Good No Good
ATTACHING THE GRILLE
Banana plug
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yamaha NS-B500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info