BEFORE MAKING CONNECTIONS, MAKE SURE THAT
THE AMPLIFIER IS SWITCHED OFF.
■ CONNECTIONS
● Connect the screw-type input terminals at the rear of the
speaker to the speaker output terminals of your amplifier
with the provided speaker cords.
● One side of the speaker cord is red and the other side is
black. Connect the (+) terminals on both the amplifier
and the speaker using this red side. Connect the (–) ter-
minals on both components using the black side of the
cord.
● Be careful not to reverse the polarity (+, –). If connected
with reversed polarity, the sound will be unnatural and
lack bass.
Procedures:
➀ Loosen the terminal knob.
➁ Insert the bare speaker wire end properly into the ter-
minal hole. [Remove approx. 10 mm (3/8”) insulation
from the speaker cord.]
➂ Tighten the knob.
➃ Test the security of the connection by pulling lightly the
cord at the terminal.
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or
the amplifier, or both of them.
SPECIFICATIONS
Type..........................2-way 3-speaker acoustic-suspension
speaker system
Magnetic-shielding type
Speaker Unit....................................10 cm cone woofer x 2
2.2 cm dome tweeter
Input Terminal.....................................................Screw-type
Impedance .................................................................6 ohm
Frequency Response ..................................70 Hz – 30 kHz
Nominal Input Power.....................................................60W
Maximum Input Power ................................................180W
Sensitivity (2.83V, 1m) ................................................91 dB
Crossover Frequency..................................................5 kHz
Dimensions (WxHxD).......................465 x 135 x 173.5 mm
(18-5/16” x 5-5/16” x 6-7/8”)
Weight .................................................3.5 kg (7 lbs. 12 oz.)
Accessories......................................Speaker cord (4m) x 1
Velcro strip x 2
* Specifications subject to change without notice due to
product improvements.
* Care should be taken not to exceed the input power val-
ues noted above.
CONNECTION TO YOUR AMPLIFIER
Center speaker
output terminals
of the amplifier
NS-C55
Tighten
Red (+)
Black (–)
Red
Loosen
Amplifier
V415010
