Bedienungsanleitung Yamaha NS-SW901 (Seite 20 von 164) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Schwedisch)

555566

Zoom out

Zoom in

Vorherige Seite

1/164

Nächste Seite

17 En

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below

or if the instructions given below do not help, disconnect the power cord and contact your authorized Yamaha dealer or

service center.

• When an excessive level of signal is input to this unit for 5 to 15 minutes, the POWER indicator starts flashing to alarm

you of the danger of damaging the power amplifier and speaker of this unit. If the signal input lasts for 5 minutes more,

this unit turns into the standby mode automatically.

• When an enormous amount of signal is input, the power of this unit is turned off immediately. To turn on this unit again,

press STANDBY/ON switch on the front panel.

TROUBLESHOOTING

Problem Cause Remedy

Power is not supplied even though

the STANDBY/ON switch is

pressed.

The power plug is not securely connected. Connect it securely.

The POWER switch is set to the OFF

position.

Set the POWER switch to the ON

position.

No sound. The volume is set to the minimum (0). Raise the volume.

Speaker cables are not connected securely. Connect them securely.

The signals from the amplifier are too low. Increase the volume of the amplifier or the

component connected to the amplifier.

The signal from the subwoofer output

terminal of the amplifier is not output.

Check the speaker mode setting on the

amplifier.

Sound level is too low. Speaker cables are not connected correctly. Connect them correctly, that is L (left) to

L, R (right) to R, “+” to “+” and

“–” to “–”.

Setting of the phase is not proper. Set the phase to the other position.

A source sound with few bass frequencies is

being played.

Play a source sound with bass

frequencies.

Set the H-CUT to a higher position.

It is influenced by standing waves. Relocate the subwoofer or change its

positioning angle.

The remote control does not

work.

Wrong distance or angle. Use the remote control within a maximum

range of 6 m and no more then 30 degrees

off-axis from the front panel.

Direct sunlight or lighting from an inverter

type of fluorescent lamp etc. is striking the

remote control sensor of this unit.

Reposition this unit.

The batteries are weak. Replace all batteries.

There are obstacles between the remote

control signal receiver on the unit and the

remote control.

Remove the obstacles.

This unit is not turned on with the

remote control of the amplifier.

(when setting “Operating the

power of this unit using the

remote control of your

amplifier”)

Wrong distance or angle. Place this unit within the operating range

of the remote control of the amplifier.

The household breaker goes off. This unit consumes much electricity when a

high level signal is input to this unit.

Turn down the volume on the amplifier

etc. connected to this unit or cut off the

power of other unused equipment.

An object has fallen into the port. Do not try to remove the object. Attempting

to remove the object may cause a

malfunction.

Contact an authorized Yamaha dealer or

service center.

Notes

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha NS-SW901 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info