Bedienungsanleitung Yamaha P-250 (Seite 86 von 102) (Englisch)

588674

Zoom out

Zoom in

Vorherige Seite

1/102

Nächste Seite

86 P-250

Appendix

Troubleshooting

Problem Possible causes Solution

The P-250 does not turn on. The P-250 has not been plugged in prop-

erly. Securely insert the female plug into the socket on

the P-250, and the male plug into a proper AC out-

let. (page 16)

A click or pop is heard when the

power is turned on or off. Electrical current is being applied to the

instrument. This is normal.

Noise is heard from the P-250

speakers. A mobile phone is being used near the P-

250 (or the ring tone is sounding). Turn off the mobile phone, or use it further away

from the P-250. Using a mobile phone in close

proximity to the P-250 may produce interference.

The overall volume is too low, or

there is no sound at all. The [MASTER VOLUME] is set too low

(page 16). Raise the [MASTER VOLUME] level.

Headphones are connected (applicable

only if the Speaker setting is [Normal

HeadphoneSW]). (page 79)

Disconnect the headphone plug.

Speaker setting is off. Set “Speaker” to “Normal” or “ON”. (page 79)

The “Local Control” function is set to off.

(page 74) Turn the “Local Control” function on.

The “InternalTG” is set to off (page 70). Set the “InternalTG” to on.

“Expression” is assigned to one of the

connected pedals or the modulation

wheel.

Assign any function other than “Expression” to the

pedal.

The Master EQ gain level is low

(page 38). Raise the Master EQ gain level.

The Part EQ gain level is low (page 68). Raise the Part EQ gain level.

The keyboard volume is lower

than the song playback volume. The volume level for the keyboard perfor-

mance is set too low. Move the [SONG BALANCE] slider toward “KEY-

BOARD” to increase the keyboard volume.

The speakers do not turn off

when a pair of headphones is

connected.

The speaker setting is on. Set “Speaker” to “Normal”. (page 79)

The buttons do not respond. While you are using a function, some but-

tons not used for the function are dis-

abled.

If a song is recording or playing, stop recording or

playback. Otherwise, press the [EXIT] button to

return to the main screen. Then, perform the

desired operation.

The sound sustains and does

not decay when I press the

pedal to which [Sostenuto] is

assigned.

With the voices in the ORGAN1,

ORGAN2, STRINGS, CHOIR, or

SYNTH.PAD group, or part of the XG

group, the sound continues sustaining

while you hold down the sostenuto pedal.

This is normal.

Higher or lower notes do not

sound correctly when the trans-

pose or octave setting is made.

The setting range for the transposition

and octave setting is C-2 - G8. (With the

normal setting, the unit’s 88 keys cover

the range of A-1 - C7.) If the lowest key is

set to a note lower than C-2, it will pro-

duce a sound one octave higher. If the

highest key is set to a note higher than

G8, it will produce a sound one octave

lower.

This is normal.

The tempo does not change

even though I recorded with

tempo changes.

Depending on the timing of the tempo

changes, the changed tempo may not be

recorded. In this case, the recording will

be played back at the original tempo.

Make tempo changes when the recording

track is selected and the red track indica-

tor is ﬂashing. The same trick applies to

editing the tempo after recording.

This is normal.

Check the location at which the tempo was

changed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha P-250 Seite 86

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha P-250

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info