669085
4
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
2
Power Requirements
Your PortaTone can run either on batteries (sold separately)
or on normal household current by using the optional
Yamaha PA-3/3B Power Adaptor (or another adaptor
specifically recommended by Yamaha).
Using an AC Power Adaptor
To connect your PortaTone to a wall socket, you will need
the optionally available Yamaha PA-3/3B Power Adaptor.
Use of other AC adaptors could result in damage to the
instrument, so be sure to ask for the right kind. Plug the
adaptor into a convenient wall outlet and its connector into
the DC IN 10-12V jack on the back of your PortaTone.
Using Batteries
Inserting Batteries
Turn the instrument upside-down and remove the battery
compartment lid. Insert six 1.5-volt size “D” batteries as
shown in the illustration, making sure that the positive
and negative terminals are properly aligned, and replace
the lid.
DC IN 10-12V
Setting Up
This section contains information about setting up your PortaTone for playing.
Make sure to read this section carefully before using the instrument.
When the Batteries Run Down
When the batteries run low and the battery voltage drops
below a certain level, the PortaTone may not sound or
function properly or may be reset to the default status. As
soon as this happens, replace them with a complete set
of six new batteries. Never mix old and new batteries or
different types of batteries (e.g., alkaline and
manganese).
To prevent possible damage from battery leakage, remove
the batteries from the instrument if it is not to be used for an extended
period of time.
Accessory Jack
Using Headphones
For private practicing and playing without disturbing
others, connect a set of stereo headphones to the rear
panel PHONES /AUX OUT jack. Sound from the built-in
speaker system is automatically cut off when you insert
a headphone plug into this jack.
Connecting a Keyboard Amplifier or
Stereo System
Though the PortaTone is equipped with a built-in speaker
system, you can also play it through an external
amplifier/speaker system. First, make sure the PortaTone
and any external devices are turned off, then connect one
end of a stereo audio cable to the LINE IN or AUX IN
jack(s) of the other device and the other end to the rear
panel PHONES/AUX OUT jack on the PortaTone.
Music Stand
Insert the bottom edge of the included music stand into the
slot located at the top rear of the PortaTone control panel.
PHONES /
AUX OUT
PSR-190/78_US.QX 56.8.27 23:03 ページ 2
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

yamaha-psr-190

Suche zurücksetzen

  • Benötige ich ein Netzteil um das K-Board einzuschalten?
    Eingereicht am 5-1-2021 17:02

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yamaha PSR-190 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Yamaha PSR-190

Yamaha PSR-190 Bedienungsanleitung - Deutsch - 14 seiten

Yamaha PSR-190 Bedienungsanleitung - Holländisch - 13 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info