Bedienungsanleitung Yamaha PSR-410 (Seite 7 von 61) (Englisch)

635589

Zoom out

Zoom in

Vorherige Seite

1/61

Nächste Seite

| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |

■ Power Supply

Your PSR-410 will run either from an optional power adaptor or batteries*. Follow the instructions below

according to the power source you intend to use.

* When batteries are used the sound of the PSR-410 may be distorted at high volume

levels. This is because the power of the amplifier is reduced when batteries are used.

CAUTION

• Never interrupt the power supply (e.g. remove the batteries or un-

plug the AC adaptor) during any PSR-410 record operation! Doing so

can result in a loss of data.

Preparation

This section contains information about setting up your PSR-410 and preparing to play.

Be sure to go through this section carefully before using your PSR-410.

DC 10-12V INHEADPHONES/

AUX OUT

SUSTAIN PEDAL

For battery operation the PSR-410 requires six 1.5V SUM-1, “D” size, R-20 or equivalent batteries.

When the batteries need to be replaced the volume may be reduced, the sound may be distorted, and other

problems may occur. When this happens, turn the power off while either the batteries are replaced or an AC

adaptor is connected.

● Using Batteries .......................................................................................................................................

When the batteries fail, replace them as follows:

Open the battery compartment cover located on the instrument’s bottom

panel.

Insert the six new batteries, being careful to follow the polarity markings on

the inside of the compartment.

Replace the compartment cover, making sure that it locks firmly in place.

CAUTION

• When the batteries run down, replace them with a complete set of

six new batteries. NEVER mix old and new batteries.

• Do not use different kinds of batteries (e.g. alkaline and manganese)

at the same time.

• To prevent possible damage due to battery leakage, remove the

batteries from the instrument if it is not to be used for an extended

period of time.



PA-3,

PA-4,

PA- 5,

PA-5B,

or

PA-40

DC 10-12V IN

Plug the DC output cable from an optional Yamaha PA-3, PA-4, PA-5, PA-

5B, or PA-40 AC Power Adaptor into the DC IN jack on the rear panel of the

PSR-410, then plug the Power Adaptor (or the AC cable of the Power Adaptor)

into a convenient wall AC power socket. The internal batteries are automati-

cally disconnected when an AC Power Adaptor is used.

CAUTION

• Use ONLY a Yamaha PA-3, PA-4, PA-5, PA-5B, or PA-40 AC Power

Adaptor to power your instrument from the AC mains. The use of

other adaptors may result in irreparable damage to both the adaptor

and the PSR-410.

NOTES

• Using the PA-5 with the PSR-410 will provide a slight increase in the

overall volume.

AC power

socket

● Using An Optional AC Power Adaptor .................................................................................................

The illustrations here are not available.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha PSR-410 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info