10
If you connect a VCR, LD player, video monitor, etc. to this
unit, you can display DSP program names and information
about other settings and adjustments on the video monitor
screen. Information is superimposed over the video image.
If there is no image on the monitor, the information will be
displayed over a monochromatic background.
TV MODE PAL/NTSC switch (General model only)
This unit is designed for use with the NTSC and PAL
television formats. Set this switch to the position for the
format your TV monitor employs.
PAL: Set to this position if your TV monitor employs the
PAL format.
* Outputs signals in the PAL format no matter which
format (PAL or NTSC) of video signal is sent from
an external video unit to this unit.
NTSC: Set to this position if your TV monitor employs the
NTSC format.
* Outputs signals in the NTSC format no matter
which format (PAL or NTSC) of video signal is
sent from an external video unit to this unit.
Note
Be sure to input a video signal which employs the same
format that your TV monitor employs, otherwise a picture will
not be played back normally.
ON SCREEN display
MIN.
AC OUTLETS (SWITCHED)
(Europe and General models)........... 2 SWITCHED OUTLETS
(U.K. model)......................................... 1 SWITCHED OUTLET
Use these to connect the power cords of your components to
this unit.
The power to the SWITCHED outlets is controlled by this unit’s
STANDBY/ON switch or the remote controller’s POWER /I
key. These outlets will supply power to any component
whenever this unit is turned on.
The maximum power (total power consumption of components)
that can be connected to the SWITCHED AC OUTLETS is 100
watts.
GND terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases better
results may be obtained with the ground wire disconnected.
(* 1):
(* 2):
