61
English
Ⅵ Selecting and editing program parameters
This adjustment can be made only by using the remote controller
and watching the monitor screen or the display panel.
Note
Information on the monitor screen would be
easier to see than the display panel.
1 Set the selector dial of the remote controller to “DSP” or
“AMP/TUN”.
2 Turn on your monitor. If the currently selected type of
display is not the full display, press the ON SCREEN
display key and select the full display.
3 Select the desired program (or subprogram) by following
the steps 2 and 3 of “Playing a source with an effect
of the digital sound field processor (DSP)” on pages
48 and 49.
The selected program name and its parameters will be
displayed on the monitor screen. The arrow-shaped
cursor points to the first parameter or subprogram name.
4 Select the parameter which you want to edit.
5 Change the value on the selected parameter to create
the effect you want.
“ ” increases the value of the selected parameter, and
“ ” decreases the value of the selected parameter. In both
cases you can hold the key down to quickly move to the
desired value.
The display will pause for a moment at the initial set value of
the parameter as a reminder. (On the monitor screen, the
*
mark at the head of the parameter name will disappear upon
reaching the initial set value of the parameter.)
EXT. DEC
.
Notes
●
For details about parameters, refer to pages 62 to 63.
●
Parameter edits made in this way will remain in effect even
if power is lost due to a power failure or the power plug is
disconnected from the AC outlet for up to about one week,
after which all parameters, as well as other adjustments or
setting changes on this unit, will return to their initial values
or conditions.
DSP or AMP/TUN
