SETTING
7-10
EC71T000
Cylinder gasket setting parts
Part number Size (thickness)
5KE-11351-60 * t=0.6 mm (0.024 in)
5KE-11351-50 t=0.5 mm (0.020 in)
5KE-11351-40 t=0.38 mm (0.015 in)
5KE-11351-30 t=0.3 mm (0.012 in)
5KE-11351-20 t=0.2 mm (0.008 in)
TUN
* Factory installed
EC71L003
Measuring piston protrusion
1. Install the dial gauge 1 and dial gauge
stand 2 to the cylinder contact surface and
set the scale of the dial gauge to zero.
Dial gauge and stand:
YU-3097/90890-01252
Offset dial stand:
YU-1037
C
NOTE:
• Finish the break-in before changing the gas-
ket.
• A change of 0.1 mm (0.004 in) for the gasket
causes a change of approximately 0.23 cm
3
(0.008 lmp oz, 0.008 US oz) of the combus-
tion chamber volume.
• After break-in, change to an appropriate gas-
ket to allow the piston protrusion to be -0.15
mm (-0.006 in) to 0.05 mm (0.002 in).
CC
CAUTION:
• Piston protruding amount must be a maxi-
mum 0.15 mm (0.006 in). Above this value,
the piston and cylinder head may contact
each other.
• Too much random piston protrusion at
low temperature may develop an abnor-
mal combustion (detonation), which may
adversely affect the intended performance
of the engine.
A Air temperature
B Piston protruding amount
