Bedienungsanleitung Yamaha YPP-200 (Seite 24 von 52) (Englisch)

583173

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

YPP-200

Using the User Song Recorder

Start Recording.................................................................................................

Recording will begin automatically as soon as you play a note on the

keyboard or press the SONG [START/STOP] button. The current

measure number will appear on the display while recording.

• A footswitch connected to the SOFT jack can be assigned to function as

a start/stop switch for song recording with the “Soft Pedal Mode”

described on page 29.

• If the metronome was on when you started recording, you’ll be able to

keep time with the metronome while recording, but the metronome sound

will not be recorded.

• You can record up to a maximum of about 10,000 notes on the YPP-200,

depending on pedal usage and other factors. The record track indicator

will begin to flash when recorder memory is almost full. If the memory

becomes full during recording, “

FUL

” will appear on the display and

recording will stop automatically. (All recorded data up to that point will be

retained.)

Stop Recording .................................................................................................

Press either the [REC] or SONG [START/STOP] button to stop

recording.

The indicator of the recorded track will glow green to indicate that it

now contains data.

Erasing a Single Track ..............................................................................

All data can be erased from either of the recorder’s tracks by engag-

ing the record mode, selecting the track you want to erase, and then

pressing the SONG [START/STOP] button twice without recording

any data.

Changing the Initial Settings..............................................................

The initial voice, tempo, reverb type, reverb depth, and effect settings

made in step 1 of the recording procedure are actually recorded by the

YPP-200.

These initial settings can be changed after the recording is finished by

pressing the [REC] button to engage the record ready mode, pressing the

appropriate track button, making the required changes, and then pressing

the [REC] button again to exit from the record ready mode and register

the changes.

If you do this, be careful not to press the SONG [START/STOP]

button or a key on the keyboard, either of which will start recording and

erase all previous recorded data on the selected track.

It is possible to cancel the operation even after changes have been

made: change tracks and then press the [REC] button to exit from the

record mode (this also cancels data for the entire song).

• The following data for initial settings cannot be changed: “Dual balance

(F3)”, “Dual detune (F3)” or “Dual octave shift (F3)”.

Press twice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha YPP-200 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha YPP-200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info