Bedienungsanleitung Yamaha YPT-300 (Seite 64 von 84) (Englisch)

617838

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

64 PSR-E303/YPT-300 Owner’s Manual

Troubleshooting

Problem Possible Cause and Solution

When the instrument is turned on or off, a

popping sound is temporarily produced.

This is normal and indicates that the instrument is receiving electrical

power.

When using a mobile phone, noise is pro-

duced.

Using a mobile phone in close proximity to the instrument may produce

interference. To prevent this, turn off the mobile phone or use it further

away from the instrument.

There is no sound even when the keyboard is

played or when a Song or Style is being

played back.

Check that nothing is connected to the PHONES/OUTPUT jack on the

rear panel. When a set of headphones is plugged into this jack, no sound

is output.

Check the Local Control on/off. (See page 59.)

Playing keys in the right hand area of the

keyboard does not produce any sound.

When using the Dictionary function (page 54), the keys in the right hand

area are used only for entering the chord root and type.

• The volume is too soft.

• The sound quality is poor.

• The rhythm stops unexpectedly or will not

play.

• The recorded data of the Song, etc. does

not play correctly.

• The LCD display suddenly goes dark, and

all panel settings are reset.

The batteries are low or dead. Replace all six batteries with completely

new ones, or use the optional AC adaptor.

The Style or Song does not play back when

the [START/STOP] button is pressed.

Is External Clock set to ON? Make sure External Clock is set to OFF;

refer to “External Clock Settings” on page 60.

The Style does not sound properly.

Make sure that the Style Volume (page 51) is set to an appropriate level.

Is the Split Point set at an appropriate key for the cords you are playing?

Set the Split Point at an appropriate key (page 44).

Is the “ACMP ON” indicator showing in the display? If it is not showing

press the [ACMP ON/OFF] button so that it does show.

No rhythm accompaniment plays when the

[START/STOP] button is pressed after

selecting Style number 098-106 (Pianist).

This is not a malfunction. Style number 098-106 (Pianist) have no

rhythm parts, so no rhythm will play. The other parts will begin playing

when you play a chord in the accompaniment range of the keyboard if

auto accompaniment is turned on.

Not all of the voices seem to sound, or the

sound seems to be cut off.

The instrument is polyphonic up to a maximum of 32 notes. If the Dual

voice or Split voice is being used and a style or Song is playing back at

the same time, some notes/sounds may be omitted (or “stolen”) from the

accompaniment or Song.

The footswitch (for sustain) seems to pro-

duce the opposite effect. For example, press-

ing the footswitch cuts off the sound and

releasing it sustains the sounds.

The polarity of the footswitch is reversed. Make sure that the footswitch

plug is properly connected to the SUSTAIN jack before turning on the

power.

The sound of the voice changes from note to

note.

This is normal. The AWM tone generation method uses multiple record-

ings (samples) of an instrument across the range of the keyboard; thus,

the actual sound of the voice may be slightly different from note to note.

The ACMP ON indicator does not appear

when the [ACMP ON/OFF] button is pressed.

Always press the [STYLE] button ﬁrst when you are going to use any

style-related function.

The harmony doesn’t sound.

The method of sounding the harmony effect (01-26) differs depending on

the selected type. For Types 01-05, turn the Auto Accompaniment on

and play it by pressing a chord in the auto accompaniment section of the

keyboard, then play some keys in the right-hand side to get the harmony

effect. For Types 06-26, turning the Auto Accompaniment on or off has

no effect. However, it is necessary to play two notes simultaneously for

Types 06-12.

The part indications, such as Right, Left and

Both Hands, do not appear—even when

pressing the [R] or [L] buttons for the Lesson.

Make sure that you are not pressing the [R] or [L] buttons while the Song

is playing. If you press one of the part buttons while playing the Song

and before starting the Lesson, these buttons serve to mute the corre-

sponding Song tracks. Stop the Song ﬁrst, then select the desired part

and start the Lesson.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha YPT-300 Seite 64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha YPT-300

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info