Bedienungsanleitung Yamaha YPT-330 (Seite 8 von 76) (Englisch)

635586

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

PSR-E333/YPT-330 Owner’s Manual

Setting Up

Be sure to do the following operations BEFORE turning on the power.

Although the instrument will run either from an optional AC adaptor or batteries, Yamaha recommends use of an

AC adaptor whenever possible. An AC adaptor is more environmentally friendly than batteries and does not

deplete resources.

Using an AC Power Adaptor

1 Make sure that the [ ] (Standby/On) switch of the

instrument is off (the backlit display is off).

2 Connect the AC power adaptor to the power supply

jack.

3 Plug the AC adaptor into an AC outlet.

Using Batteries

1 Open the battery compartment cover located on the

instrument’s bottom panel.

2 Insert the six new alkaline batteries, being careful

to follow the polarity markings on the side of the

compartment.

3 Replace the compartment cover, making sure that it

locks firmly in place.

For battery operation the instrument requires six 1.5V

“AA” size, LR6 or equivalent batteries. (Alkaline batter-

ies are recommended.) When battery power becomes too

low for proper operation, the volume may be reduced, the

sound may be distorted, and other problems may occur.

When this happens, make sure to replace all batteries,

following the precautions listed below.

If necessary, also make sure to save all important User

data (see page 45), since custom panel settings are lost

when the batteries are removed.

Power Requirements

• Use the specified adaptor (page 68). The use of other

adaptors may result in irreparable damage to both the

adaptor and the instrument.

• Unplug the AC Power Adaptor when not using the

instrument, or during electrical storms.

• Never connect or disconnect the AC power adaptor when the

batteries are installed in the instrument and the power is on.

Doing so will turn the power off, possibly resulting in loss of

the data being transferred as well as the data currently in the

transfer destination during transferring or recording of data.

WARNING

CAUTION

AC outlet

AC power

adaptor

NOTICE

• Make sure to install the batteries with the proper orientation,

maintaining the correct polarity (as shown). Incorrect battery

installation may result in heat, fire and/or leaking of corrosive

chemicals.

• When the batteries run down, replace them with a complete set of

six new batteries. NEVER mix old and new batteries. Do not use

different kinds of batteries (e.g. alkaline and manganese) at the

same time.

• If the instrument is not to be in use for a long time, remove the

batteries from it, in order to prevent possible fluid leakage from

the battery.

• Use alkaline batteries for this instrument. Other types of batteries

(including rechargeable batteries) may have sudden drops of

power when battery power becomes low, possibly resulting in

loss of data in the flash memory.

• Please use the power adaptor when transferring data to flash

memory. Batteries (including rechargeable types) can be drained

rapidly by this type of operation. If the batteries do become

drained during a data transfer, both the data being transferred

and the data currently in the transfer destination will be lost.

WARNING

NOTICE

Introduction

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha YPT-330 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha YPT-330

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info