Bedienungsanleitung Yamaha YRS-1100 (Seite 17 von 455) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Schwedisch)

516968

Zoom out

Zoom in

Vorherige Seite

1/455

Nächste Seite

15 En

Initial settings

PREPARATION PLAYBACK SETTINGS

TROUBLESHOOTING

ABOUT THIS UNIT English

CONNECTION/

INITIAL SETTINGS

■ Error messages for AUTO SETUP

If an error message is displayed on your TV, check the error

message list to solve the problem and then follow the procedure

below.

[ERROR E-1]: Press ENTER key to run the AUTO SETUP

procedure again. Or press Z key to continue the

measurement.

[ERROR E-7]: Press key to turn this unit to standby

mode, then run AUTO SETUP procedure again after turning this

unit on.

Other errors: Press RETURN key to cancel the operation

and then run the AUTO SETUP procedure again.

If the problem is difficult to be solved, configure the settings

manually in “SETUP MENU” (☞p. 32).

ERROR E-1: Please test in quieter environment.

Cause Remedy

There is too much unwanted

noise in your listening room.

Make sure that your listening

room is as quiet as possible. You

may want to choose certain hours

during the day when there is not

much noise coming from outside.

ERROR E-2: No MIC detected. Please check MIC

connection and re-try.

Cause Remedy

The IntelliBeam microphone is

not connected to this unit or

disconnected during the AUTO

SETUP procedure.

Connect the IntelliBeam

microphone to this unit firmly.

ERROR E-3: Unexpected control is detected. Please

re-try.

Cause Remedy

Some other operations were

performed on this unit while the

AUTO SETUP procedure was in

progress.

Do not perform any other

operations while the AUTO

SETUP procedure is in progress.

ERROR E-4: Please check MIC position. MIC should

be set in front of the Sound Projector and re-try.

Cause Remedy

The IntelliBeam microphone is

not placed in front of this unit.

Make sure that the IntelliBeam

microphone is installed in front

of this unit.

ERROR E-5: Please check MIC position. MIC should

be set above 1.8m/6.0ft and re-try.

Cause Remedy

The IntelliBeam microphone is

not placed in the right distance

from this unit.

Make sure that the IntelliBeam

microphone is installed more

than 1.8 m (6.0 ft) from the front

of this unit and within 1 m (3.3

ft) from the center height of this

unit.

ERROR E-6: Volume level is lower than expected.

Please check MIC position/connection and re-try.

Cause Remedy

The IntelliBeam microphone

cannot collect the sound

produced by this unit because the

sound output level is too low.

Make sure that the IntelliBeam

microphone is firmly connected

to this unit and placed in a proper

location. If the problem persists,

contact the nearest

authorized Yamaha service

center for assistance.

ERROR E-7: Unexpected error happened. Please

turn off and re-try.

Cause Remedy

An internal system error

occurred.

Press key to turn this unit

to standby mode, then run AUTO

SETUP procedure again after

turning this unit on.

ERROR E-8: Headphones are connected. Please

unplug the headphones and re-try.

Cause Remedy

A headphone is connected. Disconnect the headphone and

re-try.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha YRS-1100 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha YRS-1100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info