652632
95
Zoom out
Zoom in
Vorherige Seite
1/114
Nächste Seite
APPENDIX Troubleshooting En 95
No sound or sound is too low. Incorrect input or output cable connections. Connect the cable properly. 25
No appropriate input source has been selected. Select an appropriate input source with the input selector keys. 39
The volume is turned down. Turn up the volume. 39
The sound is muted.
Press the MUTE ( ) or VOL (+/-) key to resume audio output and adjust
the volume level.
39
There is input signal cannot be played back by this unit. Play a source whose signals can be reproduced by this unit. Change the
system settings of the source device.
110
“HDMI Audio Out” is set to “TV”. Set to “AMP”. 80
“HDMI Control” is set to “Off”. When connecting ARC (Audio Return Channel) supported TV and this unit
using an HDMI cable only, set “HDMI Control” to “On”.
80
To use this unit with “HDMI Control” set to “Off”, connect the TV’s audio
output jack to this unit’s TV (optical digital) input jack via the optical digital
audio cable.
24
Sound from an HDMI control-enabled TV is set for output from the TV’s
built-in speakers.
Use the TV’s HDMI settings to set audio output to any option other than the
TV’s built-in speakers.
No sound is coming from the subwoofer. Refer to the “No sound is coming from the subwoofer.” and “The volume of
the subwoofer is low.” problems.
96
Sound is intermittent. Audio output methods for surround playback were switched. Sound may be intermittent if the CINEMA DSP program is changed.
No sound or too small sound from
a specific channel.
The output level of the channel is muted. Raise the output level of the channel. 43, 77
The beam setting is inappropriate. Adjust the beam setting. 32, 72
The source is played in stereo playback mode. Switch to surround playback mode. 40, 42
Surround sound effects are
insubstantial.
When connecting this unit with playback device and TV digitally, the output
setting of the playback device and TV is not valid.
Refer to documentation supplied with your device and check the setting.
The playback device is set for constant output from 2 channels (PCM, etc.). Change the playback device’s audio output setting.
The listening room is not a regular shape, or the unit or listening position is
not at the center of the right and left wall of the listening room.
Relocate the unit or listening position.
14
There is no wall in the path of the sound beam. Place the sound reflection board in the path of the sound beam. 103
When “My Surround” is set to “On”, listening position is not in front of the
unit.
Listen in front of this unit.
76
Problem Cause Remedy See page
95

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

yamaha-ysp-2700

Suche zurücksetzen

  • Die maximale Lautstärke liegt bei nicht einmal 50 Watt? Eingereicht am 26-12-2020 08:40

    Antworten Frage melden
  • die yamaha Anlage schaltet sich immer nach ca, 10 Minuten ab. woran kann das liegen Eingereicht am 29-9-2018 19:15

    Antworten Frage melden
  • Bleibt BEAM Einstellung von mir gespeichrt ,
    bei Stromausfall oder stromstecker AUS ,
    Im System ?
    Wenn nein gibts Menü wo es einstellbar ist ??
    Freundlichen Grüßen
    YSP2700 ,
    Eingereicht am 7-7-2018 14:56

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yamaha YSP-2700 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Yamaha YSP-2700

Yamaha YSP-2700 Bedienungsanleitung - Deutsch - 114 seiten

Yamaha YSP-2700 Bedienungsanleitung - Holländisch - 114 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info